Votos - 4, Puntuación media: 3.5 ( )

Fabricar: Gas-Fired Products Tamaño del archivo: 519.25 kb Nombre del archivo: Idioma del manual:

8 Carefully tip stove onto back legs. Leave pallet under stove to keep stove from falling fully forward. 4. Have your assistant attach one leg using the hard- ware described. 5. Move the pallet to allow access to the other front leg hole. Attach remaining leg. 6. Remove pallet and allow stove to gently rest on all four legs. 7. Adjust leg levelers to compensate for irregularities in the hearth. Install Optional Fan It is easiest to install the optional fan kit #2767/FK26, before the stove is moved to its final location or connected to the gas line. The fan consists of a blower assembly and a rheostat switch that are connected by a wire harness. The blower attaches to a bracket at the bottom of the rear shroud. The rheostat installs at the bottom of the stove on the left of the valve. The fan kit includes a ‘snapstat’, a temperature-sensing switch which will be mounted to the blower duct just below the top plate of the stove. The snapstat automatically turns the fan on or off at approximately 109°F. The rheostat provides a range of fan speed settings from OFF (which overrides the snapstat function) to high. Kit Contents • Fan assembly with rheostat and snapstat • wire tie • control knob • retaining collar CAUTION: Sheet metal edges can be sharp. Be sure to wear protective gloves. 1. Loosen the four phillips head screws which secure the rear shroud to the stove sides. (Fig. 9) 2. Carefully pull the shroud assembly away from the rear of the stove. 3. With the rear shroud assembly in the upright position, set the bottom of the shroud on a padded surface to prevent scratching the surface. Unfasten the four phillips head screws which attach the outer shroud to the inner duct assembly. Rear Shroud Assembly ST189 Fig. 9 Loosen four phillips screws holding rear shroud assembly and remove. Remove four phillips screws holding rear shroud to inner duct assembly. Remove rear shroud. Vermont Castings Radiance Vent-Free Gas Heater 4. Attach the fan assembly to the fan bracket provided in the log box. Use #10 sheet metal screws provided with fan kit. Do not remove finger guard screws.(Fig. 10) Fan Bracket Finger Guard Snapstat Wire Rheostat Wire ST669 Fig. 10 Attach the fan assembly to the fan bracket. 5. Connect snapstat leads. Disconnect the snapstat module from the leads inside the snapstat bracket. (Fig. 11) Bend open the snapstat bracket. Use needlenose pliers to remove the black plastic grommet from the bracket. Discard the bracket. Insert the grommet and wires into the large hole at the bottom right corner of the inner shroud. Feed the snapstat wire leads through the grommet into the stove interior. Connect the two wires to the two snapstat extension leads attached to the inner shroud. Snapstat Bracket Snapstat Module Pinch Grommet to Remove Fig. 11 Remove the snapstat and grommet from the bracket and insert the grommet into the inner shroud. 6. Position the fan assembly so the ducts slide between the inner and outer shroud. The inner shroud should engage with the two slots in the ends of the bracket so that bracket and shroud are interlocked. (Fig. 12) Secure the bracket with the four sheet metal screws provided in the finish bag. 7. Route the rheostat wire assembly to the right between the inner and outer ...

Descargar ahora

Introduzca dos números de la imagen: