Votos - 4, Puntuación media: 4.5
(
)
)
|
Resumen del manual
The heater will remain hot for a time after shutdown. Allow surface to cool before touching. 13. Carefully supervise young children when they are in the room with the heater. 14. Do not use the heater if any part has been exposed to or under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water. 15. DO NOT operate the heater if any log is broken or damaged. 16. Turn heater off and let cool before servicing. Only a qualified service person should service and repair heater. 17. DO NOT operate this appliance with the safety screen removed. If the safety screen is removed from the appliance for service or cleaning, it must be replaced before operating the heater. NOTE: If any of the original wire as supplied with the appliance must be replaced, it must be replaced with a wire of at least 105°F temperature rating. Proposition 65 Warning: Fuels used in gas, woodburning or oil fired appliances, and the products of combustion of such fuels, contain chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. California Health & Safety Code Sec. 25249.6 Vermont Castings Radiance Vent-Free Gas Heater Radiance Vent Free Gas Heater Dimensions 31" (787mm) 29..." (756mm) RADIANCE 18..." (465mm) 11" (279mm) 28..." (717mm) 6..." (165mm) Drawing Not to Scale Supply Inlet 4555 Fig. 1 Radiance Vent Free dimensions. Vermont Castings Radiance Vent-Free Gas Heater Clearance Requirements Minimum Clearances to Combustible Materials Maintain clearance, (empty space), between combustible materials and the heater as specified below. BA A: To Side Wall / Trim* ........................ 4" (101.6mm) B: To Rear Wall ................................... 4" (101.6mm) ST101 B B D A C A: Maximum Alcove Depth.............. 24" (609mm) B: To Side Wall................................... 4" (101mm) C: To Rear Wall ................................. 4" (101mm) D: To Ceiling................................... 60" (1524mm) Alcove Clearances ST103a Fig. 2 Minimum wall clearances. A B C D E V W X Y Z ST694 Wall Ref. Mantel Shelf Depth Ref. Mantel from Stove Top A 7...” (190mm) V 16” (406mm) B 6” (152mm) W 14...” (368mm) C 4...” (114mm) X 13” (330mm) D 3” (75mm) Y 11...” (292mm) E 1...” (38mm) Z 10” (254mm) Fig. 3 Minimum mantel clearance. Hearth Requirements The Radiance Unvented heater must be installed on rigid flooring. If the appliance is installed on any combustible surface other than wood flooring, such as carpet or tile, a metal or wood panel must be installed to extend the full length and width of the unit. There are no other hearth or floor protection requirements. WARNING • Do not install this heater in a bathroom or bedroom. • Installation of this heater must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1. • This heater creates warm air currents. These currents move heat to wall surfaces next to the heater. Installing the heater next to vinyl or cloth wall coverings or operating the heater where impurities in the air such as tobacco smoke exist, may discolor walls. • Do not use a blower insert, heat exchanger insert ...
Otros modelos de este manual:Eléctrico - 3370 (519.25 kb)
Eléctrico - 3379 (519.25 kb)
Eléctrico - 3372 (519.25 kb)
Eléctrico - 3373 (519.25 kb)