Votos - 4, Puntuación media: 4 ( )

Fabricar: Majestic Appliances Tamaño del archivo: 519.25 kb Nombre del archivo: Idioma del manual:

Swing the top edge of the assembly toward the firebox, and center it. Fasten it by closing the latches over the top left and right edges of the frame. 2. Replace the stove front by grasping it by the left and right edges. Lift it so that tabs on the back side of the top corners engage notches at the top forward corners of the stove sides. Then gently swing the bottom of the front panel to a vertical position, and lower it till prongs on its bottom left and right corners engage with notches cast into the tops of the forward legs. (Fig. 26) Test that the front is installed securely by grasping two of panel’s vertical bars, and pulling the panel toward yourself. When the panel is in place properly you should not be able to pull the bottom of the front toward yourself without also lifting it. 3. Attach the wooden handle to the control door using the #8-32 x 2” screw from the parts bag. (Fig. 27) 4. Set the screen and the cast-iron grate into the recess in the stove top. This completes the installation and assembly of the Radiance RUVSOD. Fig. 26 Replace the front panel. ST139a Fig. 27 Attach the handle to the control door. ST197 Vermont Castings Radiance Vent-Free Gas Heater Operation The Radiance is shipped with the operable door front plate. The stove may be operated with the doors either open or closed. To open the front doors, insert the handle provided into the door latch stub and turn it to the right and up. (Fig. 28) When not in use, the handle may be stored in the handle holder on the right side of the rear shroud. (Fig. 29) Fig. 28 To open the front doors, turn handle counterclockwise. Clockwise to Close Counterclockwise to Open LP Pilot ST673 ST621 Handle Holder Natural Pilot Fig. 30 Pilot assembly location. HIcounterclockwise Turn to decrease flame height Turn clockwise to increase flame height Fig. 31 Flame adjustment knob for Honeywell valve. Flame Characteristics RADIANCE ST656 Fig. 29 When not in use, store handle in the handle holder. Your First Fire Read these instructions carefully and familiarize yourself with the burner controls shown on Page 17. Locate the pilot assembly, Figure 30. Follow the lighting instructions on Page 16 exactly. During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within the first eight to ten hours, however, you can open a window to provide fresh air to alleviate the condition. Pilot and Burner Inspection Each time you light your heater check that the pilot flame and burner flame patterns are as shown in Figure 32 and Figure 33. If flame patterns are incorrect, turn the heater off. Contact your dealer or a qualified gas technician for assistance. Do not operate the heater until the pilot flame is correct. Flame & Temperature Adjustment For units equipped with HI/LO valves, the flame adjustment is accomplished by rotating the HI/LO adjustment knob located near the center of the gas valve. (Fig. 31) It is important to periodically perform a visual check of the pilot and burner flames. Compare them to the illustration below. (Fig. 32, 33) If the flame patterns appear abnormal, contact a qualified service provider for service and adjustment. ST198 Fig. 32 Correct pilot flame app...

Descargar ahora

Introduzca dos números de la imagen: