Votos - 4, Puntuación media: 3.5
(
)
)
|
Resumen del manual
The flames should extend about 3 – 4" above the front log for natural gas and 2 – 3" above for propane (L.P.G.) gas (Figure 17). Figure 17 Main Burner – The flames at the front burner holes will be blue becoming yellowish as they hit the bark-like texture of the base and front face of the front log (Figure 17). Appliance Operation WARNING: THE LOWER CONTROL COM- PARTMENT AREA AND LOWER CONTROLCOMPARTMENT ACCESS DOOR ARE EX- TREMELY HOT WHEN THE APPLIANCE ISIN OPERATION. EXERCISE EXTREME CAREWHEN ACCESSING THIS AREA. TOUCHONLY THE FAR ENDS OF THE LOWERCONTROL COMPARTMENT DOOR WHENOPENING WHILE THE APPLIANCE IS HOT. NOTE: DIAGRAMS & ILLUSTRATION NOT TO SCALE. Step 13. Checking the System –With gas line installed run initial system checkout before closing up the front of the unit. Follow the pilot lighting instructions on pages 14 and 16. Note: Instructions are also found on the pull out panel located on the bottom surface of the appliance. When first lighting the appliance, it will take a few minutes for the line to purge itself of air. Once purging is complete, the pilot and burner will light and operate as indicated in the instruction manual. Subsequent lightings of the appliance will not require such purging. Inspect the pilot flame (remove logs, if necessary, handling carefully). The pilot flame should be steady, not lifting or floating. Flame should be blue in color with traces of orange at the outer edge. The top 3/8" (10 mm) at the pilot thermocouple should be engulfed in the pilot flame (NG only). Replace logs if removed for pilot inspection. To light the burner; rotate the gas valve control knob counterclockwise to the “ON” position. Step 14. Installing the Hood Assembly – Attach the hood assembly over the firebox opening with three (3) screws. Step 15. Installing the Screen Assembly – Position the screen assembly in front of the firebox opening, with the joint in the gasket down (Figure 18). Locate the three (3) tabs at the bottom edge of the frame into the three (3) brackets at the base of the fireplace front opening. Lean the frame back towards the fireplace. Install the three (3) 1/4"-20 x 1" Phillips pan head screws removed previously and tighten to secure. Screws Figure 18 OPTIONAL EQUIPMENT An incomparable package of options are available for use with these appliances. These options can both customize the operation of these unique appliances and enhance their beauty and charming appeal. All options are available in kit form, are easy to install and are packaged complete with all required parts and instructions. Some of the option kits need to be fitted prior to completing the installation of the appliance. The following paragraphs detail the kit options available for use with the appliances covered in this manual. These outstanding optional items can be added individually or in sets of two or more to customize your vent-free appliance to fit your homes unique needs. Kit part numbers are provided on page 12 along with descriptive ill...
Otros modelos de este manual:chimeneas - VF4000-CHN-2 (1 mb)
chimeneas - VF4000-CHP-2 (1 mb)
chimeneas - VF4000-CHN-2 (1 mb)
chimeneas - VF4000-CHN-2 (1 mb)