2 1.2 The Front Panel LEDs .............................................................................................................. 2 1.3 Factory Defaults........................................................................................................................ 3 2 Setting Up Your Computer’s IP Address..................................................................................... 4 2.1 Windows 2000/NT/XP ...................................................................

10. Inspection of the unit casing for signs of deterioration. 11. Inspection of all electrical wiring and components toassure proper connection. 12. Inspection for leaks in the refrigerant circuit. Pressure- check to determine appropriate refrigerant charge. 13. Operational check of the unit to determine working conditions. Repair or adjustment should be made at this time. 14. Your servicing dealer may offer an economical servicecontract that covers seasonal inspections. Ask for furtherdetails.

Contact your dealer for any required service. Electrical Controls and Wiring — Electrical controls are difficult to check without proper instrumentation; therefore, if there are any discrepancies in the operating cycle, contactyour dealer and request service. Refrigerant Circuit — The refrigerant circuit is difficultto check for leaks without the proper equipment; therefore, if inadequate cooling is suspected, contact your dealer forservice. Combustion Area and Vent System — The combustion area

Your dealer can help you establish a standard procedure. *See base unit Installation Instructions if field-supplied or optional factory-supplied filters are used. When replacing filters, always use the same type and size originally supplied. 4 When replacing your unit filters, always use the same sizeand type of filter that was originally supplied by the installer. Units with outdoor air capability have a cleanable filter forthe outdoor air. This filter should be checked annually andcleaned as n

5. Move the switch on the gas valves to the OFF positionand wait 5 minutes before doing any service in the sectionor on the piping. 6. Close the burner section hinged access door. 7. If unit is being shut down because of a malfunction, call your dealer as soon as possible. If unit is being shut down because the heating season hasended, restore electrical power to the unit and reset thescrolling marquee to Run mode to ensure operation of thecooling system during the cooling season. IMPORTANT: Sho

Failure to follow these instructions could damage your equipment and void its warranty. Online instructions covering customer-installable parts are available at Note: Blank drive carriers, which may fill some of the hard drive bays, follow the same replacement procedure as hard drives. If you are replacing a blank carrier with a drive module, be sure to keep the blank for possible future use. Blank drive carriers must be installed in all empty drive bays to maintain proper airflow through the

Failure to follow these instructions could damage your equipment and void its warranty. Online instructions covering customer-installable parts are available at Note: Blank drive carriers, which may fill some of the hard drive bays, follow the same replacement procedure as hard drives. If you are replacing a blank carrier with a drive module, be sure to keep the blank for possible future use. Blank drive carriers must be installed in all empty drive bays to maintain proper airflow through the

This is a safety feature. If you are unable to insert the plug into the outlet because the outlet is not grounded, contact a licensed electrician to replace the outlet with a properly grounded outlet. Do not defeat the purpose of the grounding plug! Because you are installing the server in a rack with other equipment, be certain that the power outlet and any other equipment, such as a power strip, used with the rack is designed to carry the electrical load of multiple devices. Check the document

Failure to follow these instructions could damage your equipment and void its warranty. Note: Online instructions covering customer-installable parts are available at Tools Required No tools are required for this procedure. You may, however, find a Phillips screwdriver useful in releasing the thumbscrews at the front of the server. Opening the Server The server slides open from the front of the rack. The top cover remains in place in the rack while the bottom housing (containing all interna