Votos - 3, Puntuación media: 4.7 ( )

Fabricar: Fujitsu Tamaño del archivo: 708.5 kb Nombre del archivo: Idioma del manual:

(2) A flashing time value indicates that the system is in time-setting mode. To return to the clock display you must hold down the SET button for 3 seconds. (3) You do not need to set values for both WEEKLY 1 and WEEKLY 2. If you wish, you can set values only for WEEKLY 1 or only for WEEKLY 2. (4) The allowable range for the day’s time settings is shown below. (5) If you set the OFF time to occur on the day following the ON time, the NEXT DAY caption appears on the display. Cannot set 5 min. Available range Cannot set5 min. 12:00 a.m. 12:00 a.m. En-7 TIMER MODE START/STOP CLOCK ADJUST MASTER CONTROL °F AM CLOCK WEEKLY 1COOL 1 2 1 2 To Stop Weekly Timer Operation Reviewing the Time Settings 1 2 To Stop Weekly Timer Operation Reviewing the Time Settings . To stop weekly timer while leaving the air conditioner run-Press the START/STOP button to stop the air conditioner, and ning: then proceed as follows. Press the TIMER MODE button to select NONSTOP, OFF 1 Press the TIMER MODE button so that “WEEKLY” appears TIMER, or ON TIMER. on the display. . To stop weekly timer operation and the air conditioner also: 2 Press the TEMP./DAY button to select the day that you want Press the START/STOP button. to check. 3 Press the SET TIME button (^ or Ў) to switch between the “WEEKLY 1” or “WEEKLY 2” time displays. Cancelling Selected Time Settings Press the START/STOP button to stop the air conditioner, and then proceed as follows. 1 1 Carry out steps 1 to 3 of the “Setting Up the Weekly Timer Operation” procedure to select the day you want to edit. 2 2 Press the SET button to select the ON time that you want to cancel. Be sure to select an ON time (the upper time display). Hold down the Ў side of the SET TIME button until the 4 4 3 3 time display becomes blank “ ”. Press the SET button. The first OFF time setting (“WEEKLY 1” OFF time) is deleted and replaced by a flashing blank pattern “ ”. 5 5 Press the SET button again. This completes deletion of the “WEEKLY 1” ON/OFF settings. PM PM TIMER DAY WEEKLY ON OFF2TIMER DAY ON OFF1TIMER MODE SET ZONE START/STOP CLOCK ADJUST SET TIME TEMP./DAY FAN CONTROL MASTER CONTROL DAY OFF ENERGY SAVE PM TIMER DAY WEEKLY ON OFF12 3 Example: Clearing the “WEEKLY 1” ON/ OFF times for day 4 (Thurs- day) The second ON time setting (“WEEKLY 2” ON time) appears and flashes. If you wish to delete other time settings, repeat steps 2 through 5. Once the setting has been canceled, hold down the SET button for 3 seconds. The WEEKLY display flashes briefly, and then the clock display appears. En-8 TIMER OPERATION (WEEKLY TIMER) To Change Selected Time Settings Press the START/STOP button to stop the air conditioner, and then proceed as follows. Carry out steps 1 to 3 of the “Setting Up the Weekly Timer Operation” procedure to select the day you want to edit. Press the SET button to select the time that you want to change. The selected setting flashes on the display. Each press moves you to the next setting for the selected day, as follows. s...

Descargar ahora

Introduzca dos números de la imagen: