For assistance or additional information, consult a qualified installer, service agency, or the gas supplier. WARNING Do not store combustible materials, including gasoline and other flammable vapors and liquids, near the furnace, vent pipe, or warm air ducts. Such actions could cause property damage, personal injury, or death. WARNING Never use a flame to check for gas leaks. Explosion causing injury or death may occur. WARNING If this unit is to be installed in a mobile or manufactured home ap

Tighten to 20 - 30 ft. lbs. Use backup wrench on all wrench flats. Overtightening will crush the teflon seal and may cause a leak. 506469-01 Issue 1008 Page 9 of 24 3. Connect the external equalizer line to the equalizer port on the suction line and tighten to 8 ft.lbs. 4. Strap the superheat sensing bulb to the suction header. If installing an expansion valve on an indoor coil that previously used a fixed orifice, be sure to remove the existing fixed orifice. Failure to remove a fixed orifice w

CAUTION When flushing existing line set and/or indoor coil, be sure to empty all existing traps. Residual mineral oil can act as an insulator, preventing proper heat transfer. It can also clog the thermal expansion valve, reducing system performance and capacity. Failure to properly flush system as explained in these instructions will void warranty. Required Equipment The following equipment is needed to flush the existing line set and indoor coil (see Figure 8): Two clean R22 recovery bottles,