Battery condition will affect the ability of the machine to climb a slope. Genie Z-34/22 & Genie Z-34/22N PartNo.43654 Second Edition • Ninth Printing Operator's Manual Driving on a slope Determine the uphill, downhill and side slope ratings for the machine and determine the slope grade. Maximum slope rating, counterweight uphill (gradeability): 20% (11°) Maximum slope rating, counterweight downhill: 20% (11°) Maximum side slope rating: 20% (11°) Note: Slope rating is subject to ground condition

That means every new operator should perform a pre-operation inspection, function tests, and a workplace inspection before using the machine. Genie Z-34/22 & Genie Z-34/22N PartNo.43654 Second Edition • Ninth Printing Operator's Manual Emergency Stop Push in the red Emergency Stop button to the off position at the ground or platform controls to stop all machine functions. Repair any function that operates when the red Emergency Stop button is pushed in. Selecting and operating the ground control

Using the machine for anything other than lifting personnel, along with their tools and materials, to an aerial work site is unsafe and dangerous. Only trained and authorized personnel should be permitted to operate a machine. If more than one operator is expected to use a machine at different times in the same work shift, they must all be qualified operators and are all expected to follow all safety rules and instructions in the operator's, safety and responsibilities manuals. That means every

Component damage may also result if problems are not discovered and repaired in a timely fasion. 1 Check the tire surface and sidewalls for cuts, cracks, punctures and uneven or excessive tread wear. Result: Replace the tire if uneven or excessive tread wear is found. Always replace the tire with specifications equal to original equipment manufacturer. 2 Check each wheel for damage, bends and cracks. Result: Replace the wheel if any damage is found. 3 Check each tire with an air pressure gauge a

Do not climb on the mast. Tip-over Hazards Do not raise the load unless the stabilizers (if equipped) and legs have been fully lowered and locked and the casters are in full contact with the ground. Do not raise the load unless the leg retainer pins are properly inserted through the leg and the base. Do not remove the leg retainer pins while the machine is loaded and/or raised. Do not raise the load unless the machine is on a firm, level surface. Do not raise the load unless the load handling at

Plug power tool into the power to platform GFCI outlet. To resume machine functions, move generator toggle switch to machine functions position. All functions will operate. Engine Idle Select (rpm) Select engine idle (rpm) using the symbols on the control panel. · Rabbit and foot switch symbol: foot switch activated high idle · Turtle symbol: low idle · Rabbit symbol: high idle Check Engine Light (if equipped) Light on and engine stopped: Tag the machine and remove from service. Light on and eng