This will determine what your proper wire length is to be. 2. Run spreader/vehicle harness from the rear of vehicle to switch area. Remove approx. 3'' of the black outer jacket exposing two single leads (red and black), strip a 1/4'' off each lead. Crimp 1/4'' female connector on red lead and crimp the butt connector to the black lead. Place the female spade/red wire to the on/off switch and leave the black wire for the next step. 3. Route the power harness from the battery to the switch; this w

Swing Away - Pivot Mount Installation Instructions Step 1. Insert upper & lower pivot rails into main frame of spreader. Line up the pre-punched holes on the pivot rail with the main frame, then bolt together. Holes are pre-determined and can be relocated if spreader is not centered on vehicle. Step 2. Locate top bed rail mounting brackets and set on top of pickup bed rails; Center by moving out towards the bumper. Maintain a minimum of 2” clearance between tailgate and spreader. Step 3. Locate

1-3 Wiring Instructions.............................................Pp. 4,5 Operating Instructions....................................... Pp. 6,7 Fast-Cast 175 Schematic Assembly.................. P. 8 Fast-Cast 175 Assembly & Wiring Instructions.. Pp. 9-11 Drop Utility Mount Schematic Assembly............ P. 12 3-Point Hitch Mount Schematic......................... P. 13 Fast-Cast 2000 Schematic Assembly................ P. 14 Fast-Cast 3000 Schematic Assembly................ P. 15 Drive Assembl

All external connections must have dielectric grease. 2. Read lead labels before attaching to power source or ground. 3. No other devices may be spliced into wiring harness. 4. Any repairs to wiring harness must be done with heat shrink butt connectors. 5. If inline fuse is installed, use a 35 amp slow blow (Fast-Cast 2000 and Fast-Cast 3000), and use a 60 amp slow blow fuse for Fast-Cast 4000 only. Item No. Part No. Description Qty. 1CS1P39 Male Splice Cord - 18” 1 1CS1P38 Female Splice Cord