Votos - 0, Puntuación media: 0
(
)
)
|
Otros manuales para este modelo:
Resumen del manual
Product Overview
Product Overview
Product Overview
The AD331A/AD332A PCI-X LAN cards have the following features and requirements:
•
PCI-X 133 MHz capable card can operate at 32-bit or 64-bit modes and is supported in the following
frequencies:
— PCI-X 133. Best performance is achieved by putting the card into one of the highest-performing (or
“dual-rope”) PCI-X 133 slot. To identify which slots are the highest performing slots in a particular
system, please refer to the hardware users’ guide for each system or to the I/O Slot Matrix - Entry
Level Integrity Servers at http://docs.hp.com/en/hw.html#System%20Administration.
— PCI-X 66
— PCI 33/66
•
For HP-UX 11i v2, the software driver required for this card began shipping with the HP-UX 11i v2 OE of
September 2006.
For HP-UX 11i v1, the software driver required for this card began shipping with the HP-UX 11i v1 OE of
December 2006.
Once the driver has been released on the OE, it will also be available on the quarterly application
software media.
For systems that are already running the HP-UX 11i v2 or 11i v1 OE, you can either just load the
required software driver bundle (IEther-00), or you can load the entire OE and /or application software
and you will automatically get the driver you need for this card.
•
Supports Jumbo Frames. Because Jumbo frames reduce a server’s CPU processing of network packets,
efficiency increases especially for heavy traffic. The same amount of data can be transferred in less
frames.
•
Supports HP Serviceguard for high availability and Auto-Port Aggregation (APA) for load balancing
and single-system failover.
•
Supports virtual LANs (VLANs) for increased flexibility. A Virtual LAN (VLAN) is a logical or virtual
network segment that can span multiple physical network segments. VLANs also more efficiently use switches and
end-stations by sending broadcasts and multicasts only to the intended nodes. For more information on this feature,
please see Using HP-UX VLANs on http://docs.hp.com.
•
Supports PCI-X online addition/replacement (OLA/R) on specified systems. For instructions on how to
perform online addition and replacement (OLAR) for PA-RISC-based systems running HP-UX 11i v 1.0,
see Configuring HP-UX For Peripherals. For instructions on performing OL* for Itanium-based systems
and PA-RISC systems running HP-UX 11i v 2.0 of September 2004 or later, refer to the Interface Card
OL* Support Guide .
•
Supports configuration through GUI-based system administration manager (SAM) or command line.
•
Online/Offline Diagnostics.
•
Ignite-UX support.
•
Supports vPars on HP-UX 11i v1 and 11i v2. Enables creation of additional partitions per server.
•
Card resident EFI driver version 3.0.03.
•
On board Checksum Offload (CKO) to enhance server efficiency and performance over TCP, UDP, and
IPv4.
3
...Otros modelos de este manual:
Equipo de red - HP Gigabit Ethernet and 100Base-T Cards (241.68 kb)
Equipo de red - HP-UX 11i v1 I/O Cards (241.68 kb)
Equipo de red - HP-UX 11i v2 I/O Cards (241.68 kb)
Equipo de red - HP-UX 11i v3 I/O Cards (241.68 kb)