Read all instructions before using this sewing machine. This sewing machine is designed for household use. DANGER-TO REDUCE RISK OF ELECTRIC SHOCK: A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electrical outlet immediately after using and before cleaning. Warning -To reduce the risk of burns, fire, electric shock or injury to persons... 1. Do not allow to be used as a toy. Attention is necessary when this sewing machine is used by o

Open the shuttle cover. 3. Open hinged latch of bobbin case and pull bobbin case out of machine. Release the latch and the bobbin will fall out. As long as you hold the bobbin case latch open, the bobbin cannot drop out. RE MOVING THE BOBBIN CASE AND BOBBIN 1. Raise the presser foot and turn the balance wheel towards you until the thread takd-up lever is at its highest position. 8 WINDING THE BOBBIN English 1. Draw thread from spool through bobbin winder tension disc as shown. 2. Pull end of thr

The higher the number, the thicker the needle. A STRETCH needle isstretch needle recommended for stretch fabrics. * Do not use any needle which is bent or blunted. 5 REMOVING AND ATTACHING THE PRESSER FOOT To Remove: 1. Turn the balance wheel towards you until the needle is at its highest position 2. By lifting the lever on the back of the foot holder, the presser foot will drop off. Note: *Do not force the presser foot to remove it. To Attach: 1. Place the presser foot so that the pin on the fo

elastic fabrics and stretch lace, lingerie stretch knit. Simply stitch elastic into place, making sure it is The stitch is decorative as well as useful. evenly spaced. To do this, mark the correct length piece into quarters, then match these markings with center front and side seams. Model 377 Model 374 Model 373/372 Presser foot zigzag foot zigzag foot Pattern selector C ( ) F( ) Stitch length dial 1 to 2.5 1 to 2.5 Presser foot zigzag foot Pattern selector C( ) Stitch length dial S.S. DECORATI

The marks in the stitch display correspond to the patterns shown on the panel respectively, as follows: A ( ) straight stitch, middle needle position B ( ) straight stitch, left needle position C ( ) zigzag stitch with variable width D ( ) tricot stitch automatic buttonhole sewing( ) 2. Open the shuttle cover. 3. Open hinged latch of bobbin case and pull bobbin case out of machine. Release the latch and the bobbin will fall out. As long as you hold the bobbin case latch open, the bobbin cannot d

Contact the manufacturer or its service agent for repair in the event of failure if the machine is with 240mW LED lamp, which is not user-replaceable. Replace bulb with same type rated 5 watts if the machine is with 5W lamp. WARNING -To reduce the risk of burns, fire, electric shock, or injury to persons: 1. Do not allow to be used as a toy. Close attention is necessary when this appliance is used by or near children. 2. Use this appliance only for its intended use as described in this manual

In the same operation, the fabric is trimmed, serged and gathered by the constriction of the elastic tape. Preparing the sewing machine Differential feed setting: set at “N” position Stitch length: Needles: Thread tension: 4-5 use 1 or 2 needles, depending on tape width standard setting Inserting the elastic tape • Loosen screw (2) so that brake (1) at opening (4) is opened by 1.5 to 2 mm. • Place in elastic tape (3) and pass it back under the foot. • Tighten brake (1) with screw (2) ag

Rethread the machine. - The needle is threaded incorrectly. Make sure that the needle is threaded from left to right. - The needle is not properly inserted. - The batteries are installed backwards. Check the placement diagram in the battery compartment and reinstall. Caution: When removing fabric after sewing, first turn the hand wheel to raise the needle to the highest position. Then lift the presser foot and remove the fabric. This will prevent the needle from bending. 3. The sewing mac

Models := EURO-PRO x 1104HV r 1104HW 1 Year Limited Warranty This warranty applies to defects resulting from imperfections in manufacture of parts entering into the manufacture and assembly of the sewing machine which this warranty accompanies, for a period of one (1) year, subject to the following conditions, exclusions and exceptions. This warranty is enforceable if said sewing machine is given reasonably good care and proper maintenance in accordance with the accompanying printed instr