For discoloration of an entire load, use phosphate detergent and Rust, brown or yellow nonchlorine bleach. Do not use chlorine bleach because it may intensify discoloration. discoloration LIQUID: Pretreat with a paste of granular detergent and water. PASTE: Scrape residue from fabric. Pretreat Shoe polish with prewash stain remover or nonflammable dry cleaning fluid. Rinse. Rub detergent into dampened area. Wash using bleach safe for fabric. Pretreat or soak in product containing enzymes. Wash u

If the washer serial number is below XC703, proceed with instructions 10 through 12. 10. In slot number 2, insert a small wire (paper clip) between the locking tab of the red wire terminal and the housing. Note: The locking tab is located in the small rectangular slot below the terminal. DO NOT push down on the contact prongs on the wire terminal. 11. Pull the red wire out of the slot. 12. Insert the red wire into slot number 4 until the terminal clicks into the housing. Gently pull on the wi

Wipe tub with a nonabrasive household cleanser, then rinse. Shake or brush excess dirt and sand from items before washing. Wash load too wet after spin. Washer is overloaded. Do not overload washer. See Washing Procedures. Load is out of balance. Rearrange load to allow proper spinning. Drain hose is kinked. Straighten drain hose. Water does not enter washer or it enters slowly. Water supply is not adequate in area. Check another faucet in the house. Wait until water supply and pressure increase

This will simplify the installation and ensure the laundry center is installed correctly and safely. Leave these instructions near the laundry center after installation for future reference. NOTE: The electrical service to the laundry center must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/NFPA 70, or in Canada, the Canadian Electrical Code, CSA C22.1 NOTE: The gas service to the laundry center must conform with local codes and ordinances

En un lugar donde puede haber goteos de agua o quede expuesta a las inclemencias del tiempo. 2. En un area donde pueda entrar en contacto con cortinas, cortinajes o cualquier otra cosa que obstruya el flujo de combustion y ventilacion de aire. 3. Sobre alfombras. El piso DEBE ser firme con un desnivel maximo de 1 pulgada (2,54 cm). INSTALACION DENTRO DE UN NICHO O ARMARIO 1. Si la secadora es instalada en un dormitorio, cuarto de bano, nicho o armario, el tubo del escape DEBE ser instalado hacia

- PELIGRO DE EXCESO DE PESO - Para evitar lesiones en la espalda u otro tipo de lesiones, mas de una persona debera levantar o mover la secadora. hacia el exterior ranura delantera lengueta “B” DESLICE HACIA ATRAS INCLINE COLOQUE LAS LENGUETAS TRASERAS INSTRUCCIONES DE INSTALACION DE LA LAVADORA DE 3.1 pies cubicos 18 C4) Fijacion de los accesorios de instalacion de la lavadora D4) Montaje de la lavadora E4) Instalacion o reinstalacion de la lavadora 1. Lea las siguientes instrucciones para inst

Pasos de Funcionamiento Lea los Procedimientos para el Secado en su Manual del Usuario. Alli encontrara explicados los pasos de funcionamiento mas completos. 1. Prepare las prendas para el secado. 2. Controle que el filtro de pelusa este limpio y en su lugar. 3. Cargue la secadora. Si desea agregue una hoja de papel suavisante. 4. Cierre la puerta de la secadora. 5. Seleccione los controles de Temperatura. 6. Gire el selector de ciclo en el sentido de las agujas del reloj hasta llegar a la posic

27” (69 cm) WideLAUNDRY CENTER Washer -Dryer Use and Care Guide CENTRO DE LAVANDERIA de 27" (69 cm) de anchoLavadora -Secadora Manual de Uso y Cuidado P/N 137232600A (0906) TABLE OF CONTENTS Important Safety Instructions.................................................................................................................................2-4 Washing Procedures.................................................................................................................................

• A suitable drying temperature, dryness level and options will automatically be indicated for the cycle selected. See the “Dryer Settings Chart” for more details. • To change the drying temperature and dryness level, press the Temp or Dry Level buttons to scroll to the desired settings. • To select or delete an option, press Options; then, while the indicator is blinking, press Select. The indicator will light when the option has been selected. It will no longer be lighted when the option has b