Iniciar sesión:
Clasificado: Nombre ↑   Descargas   Tarifa   Tamaño ↑  
Descargado: 0   Tamaño del archivo: 3 mb   Fabricar: Grizzly  
Categoría: Pan
@name

1 To shape and sand the neck: 1. Wear a NIOSH-approved respirator and ANSI-approved safety glasses during the next step to protect against dust! 2. Use a 4-in-1 shoe rasp to shape the neck until it matches the width of the fretboard (Figure 16). Figure 16. Shaping the neck. 3. Use a flexible sanding block with #150 grit aluminum-oxide sanding paper to sand the neck until there is a consistent scratch pattern on the entire surface. Note: When hand sanding, always sand in the same direction as the

Descargado: 10   Tamaño del archivo: 217 kb   Fabricar: Grizzly  
Categoría: Pan
@name

Failure to do this may result in serious personal injury. Electrical Safety If you are unsure how to attach wires to terminals, DO NOT continue. Contact a qualified electrician for assistance. Connecting wires improperly may cause them to come loose or contact other wires, which can cause electrocution, fire, or a short. ▲warning Electrocution or fire could result if this motor is not grounded correctly or if your wire connections do not comply with local and state codes. Ensure compliance b

Descargado: 9   Tamaño del archivo: 2 mb   Fabricar: Grizzly  
Categoría: Pan
@name

since 12/01) Hardware Recognition Chart Clean up the unpainted surfaces are coated with a waxy oil to prevent corrosion during shipment. remove this protective coating with a solvent cleaner or degreaser, such as shown in figure 5. For thorough cleaning, some parts must be removed. for optimum performance from your machine, clean all moving parts or sliding contact surfaces. avoid chlorine-based solvents, such as acetone or brake parts cleaner that may damage painted surfaces. always follow the

Descargado: 0   Tamaño del archivo: 6 mb   Fabricar: Grizzly  
Categoría: Pan
@name

Turning the dial clockwise moves the slide toward the workpiece. Compound Rest Handwheel The compound rest handwheel controls the position of the cutting tool relative to the workpiece. The graduated dial is adjustable using the same method as the dial on the cross slide. Angle adjustment is held by two hex nuts on the base of the compound rest. To determine and set the needed spindle RPM for cutting: 1. Use the table in Figure 31 to determine the cutting speed required for the workpiece mat





Categoría