5 seconds after pressing the I F I key. CAUTION:- You must press the 2nd function while the F indicator is lit, or the radio will perform the function printed on the key, rather than the function printed above it. • M: Memory key The m key is used to select the desired memory channel. The operation is similar to that of the F i key, in that, the M indicator will illuminate for 5 seconds in the LCD display. CAUTION:- The memory channel must be selected within 5 seconds of pressing the IM |

TH-41 5E: 430 MHz FM transceiver with Tone. (with Tone Burst for U.K. version) TH-315A: 220 MHz FM transceiver with DTMF. TH-215A: 144 MHz FM transceiver with DTMF. TH-215E: 144 MHz FM transceiver with Tone. (with Tone Burst for U.K. version) SAVE THIS INSTRUCTION MANUAL. Under normal circumstances, the transceiver will operate in accordance with these operating instructions. The transceiver was preset at the factory and should only be readjusted by a qualified technician with proper test eq

The F indicator will illuminate. 3. Press the |0 I key within 5 seconds. The selected memory channel number will flash as an indication the Memory Channel has been locked out. NOTE:- The channel number will not flash while the display is showing M and the listing of the memory channels that contain data. It will only flash when you recall the individual memory channel from the front panel directly. 4. To cancel the lockout press the desired memory channel number key and then press the lF and

In the United Kingdom a 1750 Hz tone burst at the beginning of each transmission is used. Since use of these tones is required in the U.K. and in Europe the tone encoder is included as standard equipment. Tone frequency selection To select the tone frequency, press the F and the R/TONE.F key. The display will show a operating tone frequency. Press either the A key or the ▼ key momentarily, the frequency will change 1 step up or down. Press the enter key to complete the selection. Tone Squelc

Do not allow the battery to charge for greater than 1 5 hours. The useful life and battery performance will be reduced if you exceed the recommended charge period. NOTES:-— • Turn off the power switch before charging. • Recharging should be done within an ambient temperature between 10°C~40°C (50°F~ 104°F). Recharging performed out of this range may not fully charge the battery. MANGANESE or ALKALINE BATTERIES Load 6 x R6 (AA) manganese or alkaline batteries in series in the supplied batter

Lesch 2009-09-27 1.0.8 G Released Software dependencies B.Werner 2010-05-11 1.0.8 H Released Blue Sign Cable clarifications B. Werner Software dependencies This revision of the Manual is valid for the Software version (s) below stated and future versions unless otherwise noted (ref.: / ). Date AIS software Version Status Comments Responsible 2009-07-21 2.0.S116.X714 Released New GPS Module. New way to store ship dimensions A. Lesch 1 General Introduction 1.1 Description of AIS What does the abbr

- Mercury founder E. Carl Kiekhaefer sold his first outboard engine in 1939, determined to raise engine standards throughout the marine world. Today when you experience the superior supercharged power of Verado®, the smooth control of Digital Throttle & Shift or the lightning-fast acceleration of Fury™ propellers, it’s easy to see why Mercury remains focused on the lofty goals of its originator. With 70 years of dedication, passion and innovative engineering invested in the advancement of marine

(Messages printed out automatically.) Manual Printing (MANU) Setting Press [[ o 1 key. No. Printing Timing of I o j key pressing Example Printout 1 Contents of {MF/HF call message} (VHF) (Select on “CALL” menu.) During “MF/HF call message” diplay to (VHF) “Ready for calling” display. © 2 Contents of all transmitted logs {Xmitted log No. < >} (Select on “XMT” menu.) Displayed TXmitted log No. < >J (To stop printing, press ( cancel j ■) 1 - 34 j /■ No. Printing Timing of [j o jkey pres

Installation Instructions) [ROM Version No.: 40] For the sake of brevity, we use the term "DSC-5 (R)“ to refer to both the DSC-5 (hanger type) and DSC-5R (rack mount type). f FURUNO ELECTRIC CO., LTD. I NISHINOMIYA, JAPAN ©FURUNO ELECTRIC CO., LTD. 9-52, Ash i hara-cho, N i sh i nom i ya, Japan 662 Telephone: 0798-65-2111 Telefax: 0798-65-4200 All rights reserved. ; Printed in Japan FIRST EDITION T APR 1991 OCT. 29, 1 997 (TATA) PUB. No. OME—55220 DSC—5/5R *00080215800* 00080215800

CLOCK ■ Digital Clock The transceiver has a digital clock display. • Clock Display 1. Press the F key, then the LOW/CLOCK key. The transceiver will display a 24-hour digital clock. 2. To return to the frequency display press the LOW/ CLOCK key again. CO CLOCK LOW H APO • Set the Clock (Hour arid Minute) 1. In clock mode press the 9 key, the hour will flash. 2. Rotate the tuning control to set the hour. 3. Press the ENT key. The minute will flash. 4. Rotate the tuning control to set