WIRING DIAGRAM INSTALLATION This wall switch can be used for either single pole or multiswitch installation. A multiswitch installation with an electronic wall switch differs from conventional installation. Read wiring instructions carefully. Use guidelines applicable to your installation. Apply the following steps for all installations. Note: The black wall switch wires have no polarity. You can use any of them. 1. Interrupt power at circuit breaker to avoid electric shock. 2. Take out and disc

Esta garantia no cubre los costos de desinstalacion y reinstalacion. Esta garantia no sera valida si se demuestra que el defecto o el mal funcionamiento se deben a un dano que ocurrio cuando el producto estaba en posesion del consumidor. La unica responsabilidad de AUBE sera la de reparar o reemplazar el producto de acuerdo con los terminos aqui establecidos. AUBE NO SERARESPONSABLE DE NINGUNA PERDIDA NI DE NINGUN DANO DE NINGUN TIPO, INCLUIDOS LOS DANOS IMPREVISTOS O DERIVADOS QUE RESULTEN, DIR

• Installation • Cut power at the circuit breaker to avoid electric shock. • Remove the existing switch. (For a 3-way installation, identify and label the wire that is connected to the “common” screw.) • Install the new switch (refer to the appropriate section below). • Apply power at the circuit breaker. NOTE A: The white wire is not the neutral wire but the wire going to the load. SINGLE-POLE INSTALLATION 120 VAC Neutral Line See NOTE A 120 VAC Line Neutral Connect wires "2" and "C" of TI034-3