Fabricar: HP
Tamaño del archivo: 74.62 kb
Nombre del archivo:
|
Otros manuales para este modelo:
Resumen del manual
There are two I/O modules on of the rear of the disk enclosure. See
LED name
LED Status
Description
Figure 1 for the locations.
A fault of lesser import-
Blinking
ant was detected on the
module
Solid
I/O failed to start
• Use the locate feature that flashes the blue LED to ensure that the
correct IO module that needs replacing has been identified.
1. I/O module A
2. I/O module B
Removing an I/O module
Figure 1 I/O module locations
1.
Schedule a maintenance window.
2.
Use the locate feature that flashes the blue LED to ensure that the
Verifying component failure
correct IO module that needs replacing has been identified.
3.
Stop all access to the storage, or force all I/O through the other
Before replacing the module, check the following and confirm with HP
I/O module.
support that it has failed:
4.
Remove all cabling from the module, making sure to label them to
• Analyze any failure messages received. HP fault monitoring software
facilitate recabling later.
provides a recommended action.
5.
Squeeze the button on the bottom of the locking lever (1) and rotate
• Check the I/O module LEDs.
out the handle (2).
Table 1 I/O module LED descriptions
6.
Position one hand under the module, and with the other hand, pull
the module out of the enclosure (3).
LED name
LED Status
Description
No cable, port not con-
Off
nected
SAS Port Link (Green)
The port is being identi-
Blinking
fied
Solid
Healthy
No cable, port not con-
Off
nected
Error detected by Applic-
Blinking
SAS Port Error (Amber)
ation client
Installing an I/O module
Error, fault conditions
Solid
detected on the port by
1.
Open the locking lever on the I/O module.
I/O module
2.
Insert the module into the enclosure opening.
Not being identified or
3.
Push the module into the enclosure until a click is detected when
Off
no power
fully seated.
Module unit identifica-
tion (Blue)
The module is being
Blinking
identified
No power or firmware
Off
fault
Module Health (Green)
Starting up and not
Blinking
ready, performing POST
The module is operating
Solid
normally
4.
Connect the cables to the replacement module, making sure they
Module Fault (Amber)
No fault conditions de-
are connected to their designated ports.
Off
tected on the module or
no power
5.
Restart I/O through the module.
Page 2
...Otros modelos de este manual:
datos de dispositivos de procesamiento - HP D2600 Disk Enclosure/S-Buy (74.62 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 2TB 6G SAS 7.2K LFF DP MDL HDD 12TB Bundle (74.62 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 3TB 6G SAS 7.2K LFF Dual port MDL HDD 18TB Bundle (74.62 kb)
datos de dispositivos de procesamiento - HP D2600 w/6 450GB 6G SAS 15K LFF Dual Port Enterprise HDD 2.7TB Bundle (74.62 kb)