d. Return air openings must have 40 square inches minimum free area including the filter. e. Return air to the air conditioner must be filtered to prevent dirt accumulation on air conditioner cooling surface. 5. Air Distribution System Installation a. Dometic Corporation recommends the basic configuration shown on page 7, for installing this air conditioner system. We have found by testing, that this configuration works best in most applications of this air conditioner system. It is the responsi

Parking the RV in a shaded area 2. Using window shades (blinds and/or curtains) 3. Keeping windows and doors shut or minimizing us age 4. Avoiding the use of heat producing appliances Operation on High Fan/Cooling mode will give optimum or maximum efficiency in high humidity or high outside temperatures. Starting the air conditioner early in the morning and giving it a "head start" on the expected high outdoor ambient will greatly improve its ability to maintain the desired indoor temperature. F

Refer to Operating Manual or Users Guide for a description of the air conditioner operation. Micro-ThermFilterSystemMicro-Therm Filter System CLEAN Return Air Cover FIG. 25 Grill Foam Divider Ceiling Template Slider Filter Handle Genesis Air Filtration System Return Air Kit 1. Install the slider in the return air cover and raise it to the ceiling template. Route the filter indicator wires from the return air cover through the template slot leaving about 3” between. Place the front of the return

Modification of this product can be extremely hazardous and could result in personal injury or property damage. Lire et comprendre ce manuel avant de proceder a l'installation, a des reglages, de l'entretien ou des reparations. L'installation de cet appareil doit etre effectuee par un reparateur qualifie. Toute modification de cet appareil peut etre extremement dangereuse et entrainer des blessures ou dommages materiels. MODEL 630025.331 Roof-Top Heat Pump used with 3106152.006 Mechanical Air Di

See Section D-3. 2. Control Cable Installation A 4-conductor control cable must be routed from the roof opening to the Comfort Control CenterTM. a. Choose the shortest, most direct route from the 14-1/4" x 14-1/4" (±1/8") opening to the Comfort Control CenterTMlocation selected. Leave 6" of cable extending through the wall. See Section D-6. b. The control cable that should be used is a flat, 4-conductor telephone cable. c. The control cable must be terminated with two (2) RJ-11-6C4P telephone co

See FIG. 21. FIG. 21 Foam Divider Adhesive Peel Off Paper - Center Divider - Stick To Rear Flange On Ceiling Template d. Start each mounting bolt through the ceiling template and up into the unit base pan by hand. EVENLY tighten the three bolts to a torque of 40 to 50 inch pounds. This will compress the roof gasket to approximately 1/2". The bolts are self locking so over tightening is not necessary. CAUTION If bolts are left loose there may not be adequate roof seal or if over tightened, damage

2. Don’t touch electrical switches. 1. Ouvrez les fenetres. 2. Ne touchez a aucun interrupteur. 3. Eteignez toute flamme nue. 3. Extinguish any open flame. 4. Avertissez immediatement votre fournis4. Immediately call your gas supplier. seur de gaz. FOR YOUR SAFETY Pour votre securite Do not store or use gasoline or other Ne pas entreposer ni utiliser de l’essence ni d’autres vapeurs ou liquides inflammables aflammable vapors and liquids in the proximite de cet appareil ou de tout autre vicinity