Iniciar sesión:
Votos - 0, Puntuación media: 0 ( )

Manual de usuario HP, modelo HP NetServer LC 3

Fabricar: HP
Tamaño del archivo: 183.54 kb
Nombre del archivo:
Idioma del manual:en
Enlace gratuito para este manual disponible en la parte inferior de la página



Otros manuales para este modelo:

Resumen del manual


9. Depress the black retainer latch and rotate the purple locking lever over the retainer.
The green power LED next to the slot turns on and the PCI Hot Plug 'n Play Wizard
automatically starts on your Windows NT server.
10. Follow the instructions of the PCI Hot Plug 'n Play Wizard. Before the wizard completes,
you may need to configure the adapter. For configuration instructions, refer to the
documentation provided with your adapter.
11. Select Finish to close the wizard and complete the installation. DO NOT REBOOT.
CAUTION
Do not perform a Hot Add during periods when the NetServer is busy. Some
drivers may disable interrupts for an excessive period during the Hot Add
operation.
Online Replacement (Hot Swapping) of a PCI Hot Plug Board:
NOTE
You can Hot Swap an adapter only if it is the passive adapter, or inactive adapter
of a fault-tolerant pair.
If an adapter in a fault-tolerant pair has failed:
1. Log on to Windows NT 4.0 as a user within the Administrator Group.
2. Open the PCI Hot Plug n' Play Wizard by selecting PCI Hot Plug Applications 3.0, then
PCI Hot Swap Wizard from the Start Menu (the utility must already be installed as
described in the previous section "Installing the PCI Hot Plug Software").
3. When the wizard prompts you to swap the adapter, open the NetServer chassis in order to
access the hot plug PCI slots.
4. Locate the slot with the failed adapter. The amber attention LED will be on.
5. Rotate the purple locking lever next to the slot (see illustration below).
6. Lift the black retainer (see illustration below).
Retainer
Locking
Lever
Opening the PCI Latch and Retainer (LH)
Opening the PCI Latch and Retainer (LT)
7. Remove the adapter board and any applicable adapter cables. You may need to pull on the
adjacent slot separator to eject the adapter from its slot.
8. Insert the replacement adapter board firmly into the slot.
9. Connect any applicable adapter cables.
10. Depress the black retainer latch and rotate the purple locking lever over the retainer. The
PCI Hot Plug 'n Play Wizard will continue to run until the adapter configuration is complete.
2

...

Otros modelos de este manual:
Computadoras - HP NetServer LC 2000 (183.54 kb)
Computadoras - HP NetServer LC 2000r (183.54 kb)
Computadoras - HP NetServer LC II (183.54 kb)
Computadoras - HP NetServer LC Plus (183.54 kb)

Comentarios



Tu reseña
Tu nombre:
Introduzca dos números de la imagen:
capcha





Categoría