• The power cord to the IEC 320/C14 connector should be of the appropriate gauge to carry a 10A current @ 120VAC, or a 5A current @ 230VAC for the cable’s length, to meet the requirements of applicable electrical codes. • A minimum of 30mm clearance should be provided at each end of the charger for vented models. • The charger should not be installed in locations which restrict air flow. page 4 Curtis 1604/08 Manual OPERATION 4 4.1. Charging the Battery Note: If a DC output adapter is used, conn

WARNING – Failure to install and operate the charger in accordance with these instructions may result in damage to the charger or injury to the operator. 2. WARNING – Never place the charger directly above or below the battery being charged. Gases or fluids from the battery will corrode and damage the charger. Locate the charger as far away from the battery as the output cable allows. 3. WARNING – Explosive gases may result from charging. Provide adequate ventilation during charging. Prevent fla