For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult your licensed plumber for installation of this system. This system and its installation must comply with state and local regulations. The use of saddle valves is not permitted. If this is your first experience having soft, conditioned water in your home, you’ll be amazed at the marvelous difference it makes. We promise that you’ll never want to be without it again. Congratulations, too, on select

Equipment Needed • Safety glasses • Rubber gloves, sanitary • Wash cloth, clean and lint-free • Liquid dish soap • Household bleach - unscented only (5-1/4% sodium hypochlorite) • Plastic storage bag • Manual air pump • Plastic bucket • Plastic bowl • Silicone lubricant, FDA approved Have all components and supplies on-hand and ready before beginning procedure. A clean work area and equipment are essential to properly clean and/or sanitize the system (i.e., clean hands, tools, work surface and c

5. Inserte el nuevo filtro alineando los tubos de salida en el filtro con los orificios de entrada del cuerpo del surtidor y presionando suavemente hacia adentro y abajo. Una vez completa la instalacion del cartucho del filtro, el surtidor portatil emitira tres pitidos y el indicador de vida del filtro volvera automaticamente al punto inicial. 6. Reinstale la cubierta del filtro colocando la lengueta de alineacion en la muesca correspondiente en el cuerpo principal del surtidor portatil y empuja

4. Conecte el surtidor portatil a la manguera alineando los puntos situados en el conector de un cuarto de vuelta (18) y el surtidor. Empuje el conector de un cuarto de vuelta insertandolo en el conjunto del surtidor y voltee en sentido de las manecillas del reloj, fijandolo en su sitio. 5. Deje que el agua fria corra a traves del nuevo filtro durante 5 minutos para lavar cualquier particula de carbono que este suelta. (Vea la pagina 24 para el modo de agua filtrada.) Una vez que estas pequenas

• No use con agua que no sea microbiologicamente segura o que no se haya desinfectado adecuadamente antes o despues de pasar por el sistema. Los sistemas certificados para la reduccion de esporas pueden ser usados en agua desinfectadas que puedan contener esporas filtrables. • Los filtros MicroTech estan disenados para ser reemplazados despues de dispensar 200 galones de agua filtrada (aproximadamente 3 meses). Las condiciones del agua y el uso pueden afectar la vida del filtro. • El indicador e

• Single, Duplex, Triplex, or Quad Configurations • Regeneration initiation by choice of time clock, meter or differential pressure switch. • Carbon Filters – For reduction of organics (flow rates up to 39gpm), or chlorine (flow rates up to 77gpm). • Depth Filters – Flow rates up to 193gpm. • Top-Mounted Control Valve – Keeps plumbing connections simple and adaptable. Full flow porting with rounded orifices and wide-open cartridges promote good flow characteristics and low pressure fluctuations.

lb 870 1,150 1,750 2,530 3,550 7,000 8,800 10,800 18,500 25,000 kg 390 520 790 1,150 1,610 3,175 4,000 4,900 8,390 11,340 NOTES: 1 Service flow rates are based on 7 gpm/ft2 (26 L/m2/min) for Normal and 15 gpm/ft2 (57 L/m2/min) for Peak Flow rates. Actual service rate can vary from 2 to 20 gpm/ft2 (8 - 76 L/m2/min) depending upon the application and the raw water. 2 Backwash flow rates are based on 12-14 gpm/ft2 (45-53 L/m2/min) using 50° F (10° C) water. A different backwash rate may be required

–contact between sensor and factory for greater IQS/3 Controller distance requirements *Number of pipe diameters required adjacent to flow sensor location dependent on source of upstream turbulence: Electrical Output: *Requires DC Current from IQS/3;+5VDC @ 10 ma. Environmental: Ambient temperature Relative Humidity: Dimensions: X: 1/2" thru 4" = 3.50" 5" thru 8" = 5.00" 10" up = 7.75" ) 15 minimum/ 55 maximum Open Collector, transistor, sinking -40F to 1220F 0% to 100% Non-condensing *Refer to

As a manufacturer, we do not know the characteristics of your water supply or the purpose for which you are purchasing this product. The quality of water supplies may vary seasonally or over a period of time, and your water usage rate may vary as well. Water characteristics can also differ considerably if this product is moved to a new location. For these reasons, we assume no liability for the determination of the proper equipment necessary to meet your requirements, and we do not authorize oth

A wide variety of installation fittings are available to assure compatibility with many commonly used plumbing materials: •Threaded galvanized •Copper sweat •PVC; CPVC •Iron •Steel The XLF flow sensor package is comprised of: •One (1) paddlewheel insertion type flow sensor element sized for the specified pipe diameter •One (1) installation fitting for the specified pipe type and size. How It Works The solid state paddlewheel flow sensor works on a simple, but precise, electro- mechanical princip