RPO codes can be found in the glove box, on the trunk lid or hatch, or on the drivers side door jam near the latch. If you find the RPO code & it does not match one listed above for your particular vehicle, you should not use this harness. INST70-2054 GMC - Envoy 2000-01 w/ Bose System..................................................9 - Envoy 2002-04 w/ RPO code UQA...............................................8 - Envoy XL 2003-04 w/ RPO code UQA.........................................8

A POWER HARNESS IS SUPPLIED TO ALLOW THE USER TO WIRE THE AFTERMARKET RADIO UP WITHOUT THE NEED TO PURCHASE A SEPARATE WIRE HARNESS. 70-8116INSTALLATIONINSTRUCTIONSToyotaPowerandAmplifierBypassHarnessTHESE HARNESSES ARE DESIGNED FOR THE 2000-04 TOYOTA AVALON, 2000-06 TOYOTA CAMRY, 2003-05 TOYOTA CELICA, 2001-06 TOYOTA HIGHLANDER, 2000-06 TOYOTA LANDCRUISER AND THE 2000-03 TOYOTA SOLARA WITH THE AMPLIFIED JBL SYSTEM. A POWER HARNESS IS SUPPLIED TO ALLOW THE USER TO WIRE THE AFTERMARKET RADIO UP W

(únicamente Concorde). 3 Desenganche el panel de terminación de la palanca de velocidades y deslice el panel de terminación hacia la parte trasera del vehículo. 4 Desenganche el panel de terminación del tablero y desconecte el cable del panel de terminación. 5 Retire (4) tornillos de cabeza Phillips que v sujetan el radio. Desconecte y retire el radio. Pase a la página de montaje del kit. CHRYSLER PT CRUISER 2DD1-2DD5 1 Desconecte el terminal negativo de la batería, a fin de evitar un corto

Desconecte y retire el radio. Pase a la página de montaje del kit. DODGE DAKOTA 2001-2004 DURANGO 2001-2003 1 Desconecte el terminal negativo de la batería, a fin de evitar un cortocircuito accidental. 2 Retire (3) tornillos de cabeza Torx T-20 del borde inferior del panel que se encuentra debajo de la columna de la dirección y quite a presión para retirar el panel. 3 Retire (2) tornillos Phillips del panel de grupo de instrumentos que se encuentra arriba de los indicadores. 4 Retire (3) to

Continue to Final Assembly. C 4 99-8214KITASSEMBLY99-8214KITASSEMBLY DOUBLE DIN HEAD UNIT PROVISION A 1 Slide the aftermarket radio unit into the factory brackets and secure the unit to the brackets using the screws supplied with the head unit. (Figure A) 2 Secure the aftermarket radio unit and factory bracket assembly into the sub dash. (Figure B) 3 Place the Double DIN trim plate into the back of the radio housing, then attach the clock/hazard switch brack- et assembly using the (4) #6 x 3/8”

• A) Radio Housing • B) Radio Housing Brackets KIT COMPONENTS A B C D APPLICATIONS Toyota Tacoma 2005-2011 • C) Radio Housing Trim Panel • D) ISO Brackets • E) ISO Trim Plate • F) (4) #6 x 3/8” Phillips Pan Head Screws • G) (4) #8 X 3/8” Phillips Truss Head Screws • H) Double DIN Trim Plate • I) Clock/Hazard Switch Bracket E F G H 99-8214TB 99-8214TG TOOLS REQUIRED: I WIRING AND ANTENNA CONNECTIONS (Sold Separately) Harness: • 70-1761 - Toyota harness 1987-up • TYTO-01 - Toyota amp interface har

Reach under the driver's side dash and unclip the temperature control cable. Using Metra's 86-5618, pull the factory radio/climate control panel from the dash. Disconnect the switch power harness, antenna plug, radio/speaker power harnesses and vacuum hose harness. 2 CONTROL PANEL) Turn the integrated control panel over and disconnect the vent control harness ("A"), fan speed control harness ("B"), and defroster harness ("C"). Unclip the main switch harness from the side of the factory unit.

Metra recommends making connections as shown using the supplied wire harness. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit). Right Front +......... ......Gray Right Front -........... Gray/Black Left Front +............ White Left Front -.............. .....White/Black Right Rear +........... ......Violet Right Rear-............. .....Violet/Black Left Rear +.............. .....Green Left Rear-................ Green/Black 12 Volt Po

2006-20091-800-221-0932 ©2004-2009 METRAELECTRONICSCORPORATION70-1727INSTALLATIONINSTRUCTIONS HONDA CIVICwith Premium Sound SystemAMPBypassHarnessIn 2006 Honda Civics that have the Premium Sound System, there is an amplifier that drives all the speakers. This harness is designed to bypass the factory amplifier so to allow the user to use aftermarket amplifiers or to wire to the aftermarket radio. 2006-20091-800-221-0932 ©2004-2009 METRAELECTRONICSCORPORATION70-1727INSTALLATIONINSTRUCTIONS HONDA

1 1993-1995 Mercury Villager /1993-1995 Nissan Quest ............... 2 1996-1998 Mercury Villager/ 1996-1998 Nissan Quest ............... 3 1999-2002 Mercury Villager /1999-2003 Nissan Quest................ 4 1995-1999 Nissan Sentra /1995-1998 200 SX............................. 5 1995-1998 Nissan 240 SX............................................................ 6 1998-2001 Nissan Altima ............................................................. 7 1998-2001 Nissan Frontier/2000-2001 Nissan X