The high-grade magnesium alloy material is lightweight, does not rust, and memorizes the antenna's parabolic curve to maintain its shape over time. The result is the only low cost terrestrial microwave antenna sufficiently durable to survive changing climate conditions. The patented grid reflector design provides field reliability and ease of handling and installation. No secondary coating is required to prevent rust and corrosion. Breakdown packaging saves freight costs, and optional factory a

When the dipole element pairs are spaced at 90° to each other, an omni-directional or circular pattern results. When both sets of dipoles are in line (collinear - see the DB404L illustration in Figure 1), the antenna has a directional characteristic, giving an elliptical pattern as shown in Figure 2. Also, see Figure 3 for gain variation with frequency for DB404 and DB404L antennas. The change from one radiation pattern to the other is easily accomplished. The banding clamps that hold the dipole

ANTENNA MOUNT ASSEMBLY BOTTOM FEED LEG HOLE 2 3 1 FIG. 2.0 - ASSEMBLING REFLECTOR TO AZ/EL CAP MOUNT FEED AND FEED LEGS INSTALLATION Assemble feed assembly and feed legs to antenna as shown in Fig. 2.2. Insert bottom feed leg (4) into hole in bottom edge of antenna (5). NOTE: Bottom feed leg is the one with a slight bend on one end of leg, lance on opposite end, and is shorter than the two side legs (6). Install side legs (6) to antenna. From back side of antenna, secure with M6 x 30mm ( ...” x

Printed in U.S.A. . 10500 West 153rd Street . 1315 Industrial Park Drive . Fax: +1-919-989-2200 . ECN 9006666 .. . Orland Park, IL U.S.A. 60462 Smithfield, NC 27577 USA Internet: 5/04 8000284-01 VSAT ANTENNA/LIMITED TWELVE (12) MONTH WARRANTY DATE DESCRIPTION REV. 2/26/90 Changed Pages 4, 6, 7, 8, 9 and 10. ECN 9001516 A 4/20/90 Changed Pages 3, 4, 5, 6, 7, 8, 9 & 10. ECN 9001550 B 9/10/90 Changed Cover, Pages 1, 6, 7, 12 & 13. ECN 9001616 C 11/19/90 Changed Cover, Pages 1, 3, 4, 5, 6, 7, 8, 0,

DIA. NOTE: 48" may be increased, concrete and length of rebar will increase accordingly. 2 ..." O. D. DEEP FROST LINE FOUNDATIONS ............ (SEE NOTE) 1-1.5" APPROX. 2" .... (4) #3 x 24" MIN. AT 90° APART (SEE NOTE) PIER FOUNDATIONS DEEP FROST LINE FOUNDATIONS 7 15 8 5 6 9 11 13 12 4 6 14 CLAMP SURFACE 96 7 10 Junction Block (9) FIG. 4.1 - ANTENNA, ANTENNA FEED (LNB) & FEED SUPPORT LEGS ANT WIND VEL. DIM “d” CONC VOL. DIM “d” CONC VOL. GROUND POLE 90cm 80 MPH 90 MPH 100 MPH 110 MPH 125 MPH 9”

7/02 Orland Park, IL U.S.A. 60462 Internet: Other Europe: +44 1592 782612 Copyright © 2002 by Andrew Corporation Table of Contents Introduction Description Maintenance Emergency Procedures Component Replacement Specifications Purpose . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Proprietary Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Andrew installation instructions are written for such installation personnel. Antenna systems should be inspected once a year by qualified personnel to verify proper installation, maintenance, and condition of equipment. Andrew disclaims any liability or responsibility for the results of improper or unsafe installation practices. Do not install near power lines. Power lines, telephone lines, and guy wires look the same. Assume any wire or line can Do not install on a wet or windy day or when

• Use 7/8 by 2-1/4 in (57 mm) hardware Note: Angles are attached edge out with flat of angle facing inward. 301786 Figure 16 Align panning frame/azimuth pivot assembly by swinging panning frame through its entire arc. Slightly snug panning frame/pivot assembly hardware, and again swing panning frame through its entire arc. Continue this procedure until mounting hardware is ready for tensioning. Note: Do not tighten hardware on 301786/201022 azimuth pivot assemblies at this time. 21 Installation

A World of Solutions. International Telephone: +1-708-873-2307 Fax: +1- 708-349-5444 Internet: DO NOT DISCARD CONTENTS The product in this packaging was placed in the market after August 13, 2005. Its components must not be discarded with normal municipal or household waste. Contact your local waste disposal agency for recovery, recycling, or disposal instructions. HARDWARE SORTER HARDWARE SORTER DATE DESCRIPTION REV. 1/06 ECN9007200 Rev A 8/06 ECN9007484 Rev B VSAT ANTENNA/MOUNT/LNB LIMITED TWE

for #3 rebar and drilled .218 for ..4-20 self tapping grounding screw and galvanized or painted for protection. 1 - Pole and foundation design based on the following criteria: a) Uniform building code exposure B or C and 1.5 stability factor. b) Vertical soil pressure of 2000 pounds per square foot. BubbleLevelGround PoleMust BeVertical InAll DirectionsWithin .19 InchesAt Top (0.3.) c) Lateral soil pressure of 400 pounds per square foot. d) Concrete compressive strength of 2500 pounds per square