In the same operation, the fabric is trimmed, serged and gathered by the constriction of the elastic tape. Preparing the sewing machine Differential feed setting: set at “N” position Stitch length: Needles: Thread tension: 4-5 use 1 or 2 needles, depending on tape width standard setting Inserting the elastic tape • Loosen screw (2) so that brake (1) at opening (4) is opened by 1.5 to 2 mm. • Place in elastic tape (3) and pass it back under the foot. • Tighten brake (1) with screw (2) ag

3 OPERATING INSTRUCTIONS Before using your EURO-PRO Power Mixer for the first time, wash the beaters, dough hooks, whisk and stainless steel bowl in warm, sudsy water. Rinse and dry thoroughly. Warning: To avoid injury when inserting or removing beaters, dough hooks or whisk always set the speed selector on ”0" and unplug the appliance. Warning: The unit is designed for intermittent use. The maximum operating time on settings “1-3” in the " Lo" range is 10 minutes non-stop with beaters, dough ho

Keep hands, hair, clothing as well as spatulas and other utensils away from attachment during operation to reduce the risk of injury and/or damage to the appliance. Assembly See instruction manual for general assembly instructions with various accessories. Care & Maintenance Wash the food processor bowl, lid and food pusher in warm, sudsy water using regular dishwashing liquid. Do not wash in dishwasher. Dry thoroughly before using or storing. For information or assistance: EURO-PRO Operat

Care should be taken to arrange cord so that it cannot be pulled, tripped over or pinched. 3. Do notleave unattended when the system is connected to a power supply/electrical outlet. WARNING: This apliance is equipped with a grounded-type 3-wire cord (3-prong plug) . This plug will only fit into an electrical outlet made for a 3- prong plug. This is a safety feature. If the plug should fail to fit the outlet, contact an electrician to replace the outlet. Do not attempt to defeat the safety purpo

Rinse well and dry. Rev. 07/05 1 - 6” Loaf Pan (6” x 3” x 2”) 1 – 8” Square Pan (8” x 8” x 1 7/ 8”) 1 – 8” Round Pan (8” x 1 1/ 2” ) XEP552H USE & CARE Before first use, please remove any stickers found on the bakeware and rinse all the pieces with hot, soapy water. Use a soft cloth or sponge and warm soapy water to clean the bakeware, then towel dry them after every use. Neveruse steel wool or abrasive cleansers to clean as these may damage the bakeware. Excessive pre- heating of empty bakeware

Mattresses and Pillows Text Box: EURO-PRO Customer Service 1-800-798-7398 EURO-PROCustomer Service1-800-798-Remove the water tank, empty and replace it. • Store your EURO-PROSteam Cleaner in a dry area. Text Box: Additional Uses 1. Attaching Small TowelAdditional cleaning and sanitizing can be done on some upholstery and hard surfacesby attaching a cut out piece of a towel to thetriangle brush. a. Cut a square piece of towel approximately 6 inches by 6 inches. b. Place over triangle brush when i

euro-pro.com COPYRIGHT © EURO-PRO OPERATING LLC 2008 IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all instructions for use carefully and look at the illustrations before you start using the appliance. 2. To protect against risk of electrical shock, do not immerse power cord, plug or mixer in water or any other liquid. 3. Close supervision is necessary when any appliance is used by or near chil

The maximum operating time on settings “ 1- 3” in the " Hi" range is 30 seconds non- stop with beaters, dough hooks, or whisk. Beaters, Dough Hooks, Whisk: Select the attachment according to the type of mixing required. Make sure that the mixer is unplugged from power source and speed selector is set on ” 0" before inserting or removing beaters, dough hooks or whisk. Beaters: Use for liquid mixes such as creams, egg- whites, confectionery doughs, etc. insert stem end of beaters (one at a time) i

Remove the extension tube from the sweeper power head. 2. Turn sweeper power head upside down being careful Notto accidentally turn the unit ON. 3. Remove the transparent brush cover. (Fig. 1) (Refer to your owner's manual for detailed instructions.) 4. Push in on the locking tab of the gear box and lift gear box to remove. (Fig. 2 & Fig. 3) 5. Lift the brush bar end cap up from the slot. ( Fig. 4) 6. Lift the brush bar out from the bushing and slip of the belt to remove the brush bar. (Fig. 5)