Condenser Unit Model: URC-5F Index No. Description Material or Model Number Part Number Required Number R-5 to T-5 B Junction Box -2A0117A01 1 B1 Truss Head Screw 4.8, SS 7C32-0408 2 1 Unit Base -2A1886G01 1 2 Condenser -216519-02 1 2a T2 Screw 4.8, SS 7P32-0408 2 3 Shroud -216522-01 1 3a T2 Screw 4.8, SS 7P32-0408 4 4 Fan Motor 63 Watt, GEHI 4A3201-01 1 4a Flat Washer 8-32, SS 7W22I0832 4 4b Split Lock Washer 8-32, SS 7L22I0832 4 4c Hex Nut 8-32, SS 7N02I0832 4 5 Fan Blade -4A1493-01 1 6 Fan Mo

Cleaning Instructions................................................................................................... 11 1. Cleaning Procedure...............................................................................................11 2. Sanitizing Procedure – Following Cleaning Procedure.......................................... 13 C. Maintenance ............................................................................................................... 13 3 I. Specification AC SUPPL

No installation, service or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/ manager should not proceed to operate the ice dispenser until the installer has instructed them on its proper operation. HOSHIZAKI provides this manual primarily to assist qualified service technicians in the installation, maintenance and service of the ice dispenser. Should the reader have any questions or concerns which have not been satisfactorily

No such installation, service or maintenance should be undertaken until the technician has thoroughly read this Instruction Manual. Likewise, the owner/manager should not proceed to use this ice bin until the installer has instructed them on its proper operation. HOSHIZAKI provides this manual primarily to assist qualified service technicians in the installation, maintenance and service of the ice bin. Should the reader have any questions or concerns which have not been satisfactorily addressed,

2) Lower the back edge of the baffle into position. B. Sliding Doors 1. Removal 1) Slide the door you want to remove to the middle of the opening. 2) Raise the door up slightly. If it cannot be easily raised, slide it gently back and forth while lifting until it raises. 3) Rotate the bottom of the door out for the front door or in for the rear door. 4) Pull the door down slightly and remove. 2. Installation 1) There is a vertical ridge on one side of each door. This ridge should face the rear on

Removal................................................................................................................. 13 2. Installation ............................................................................................................. 13 B. Sliding Doors...............................................................................................................13 1. Removal...........................................................................................................

4) Remove any packing from the snout assembly. 5) Apply the gasket (included) to the perimeter of the snout assembly where it mates with the ice bin. 6) Position the snout assembly onto the bin by first placing the bottom of the assembly into the lower hole on the bin's front panel and then rotating the top towards the bin. 7) Install the four screws (included) along the top of the snout assembly. 8) Clean and wipe the interior of the bin and snout assembly with a clean cloth. Fig. 1 Snout Assem