This user’s guide provides all of the basic information required to use this system and receive the satellite entertainment you want. Detailed installation, configuration, and maintenance information is provided in the TracVision 4 Technical Manual. Throughout this manual, important information is marked for your attention by these icons: . . . . . . . . . . . . . . . . . . . . . . . . . . ... . . . . . . . . . . . . . . . . . . . . ... . . . . . . .

Be sure not to drop any loose parts in the opening. • Do not insert anything into the opening on the receiver other than the Over-the-Air Module. • Be aware that there may be parts or areas of the receiver inside the opening that are warm. • If the Over-the-Air Module is removed, be sure to replace the port cover that came with the receiver. Do not leave the opening uncovered at any time. TABLE OF CONTENTS INTRODUCTION.............................................2 INSTALLATION AND SETUP ........

2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Use only attachments/accessories specified by the manufacturer. 6. Refer all servicing to qualified personnel. Keep safety in mind while installing the DISH Pro Plus 44 Switch. In this guide, the following notes tell you when you need to pay special attention: Marks a procedure where the following may happen: • Personal injury or death may occur. • Equipment or property may be damaged. Marks the following issues: •

If your King-Dome does not operate as outlined in this manual please call King Controls at ( 800) 982-9920 or visit our website at TABLE OF CONTENTS Section Contents Page 1. INTRODUCTION.....................................................................................2 2. DEFINITION OF TERMS ........................................................................3 3. INSTALLATION..................................................................................4-10 4. OPERATION ...............

Phone line must be connected to receiver. © 2003 EchoStar Satellite Corporation. All Rights Reserved.

Run wires from the back of the dome unit to the roof edge, then along edge to location where wiring will be fed into the vehicle. (If installing an optional second receiver, run auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12-18 inches (Fig. 10). 12. Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed wiring down through hole. Seal opening with roof compatible sealant so that it is entirely waterproof (inside and outsid