2232MS) INSTALLATION AND SERVICE MANUAL MANFACTURED BY IMI CORNELIUS INC. ANOKA, MINNESOTA 55303–1592 BEVERAGE CONTROL PANEL ASS’Y Manual Part No. 0713 June 5, 1991 Revised: April 23, 1992 Control Code A THIS DOCUMENT CONTAINS IMPORTANT INFORMATION This Manual must be read and understood before the installation and operation of this Equipment. IMI Cornelius Inc. 1990–92 Printed in U.S.A. GENERAL DESCRIPTION Warranty Registration Data (to be filled out by customer) Model Number; Serial Number; In

30.30” (BACK SIDE OF DISPENSER) 1.67” 27.40” ICE MAKER DROP ZONE 21.50” AND BIN STAT MUST FIT WITHIN THE 27.40 X 21.50” OPENING Figure 1 ! WARNING: Disconnect power to the unit before installing adaptor following all lock out / tag out procedures established by the user. Verify all of the power is off to the unit before performing any work. Failure to comply could result in serious injury, death or damage to the equipment. ! WARNING: All of the attachment screws and plates must be installed as d

To turn OFF the COLD timer, press the “AUTO TIMER” clock button(s) until the light(s) on the clock button(s) turns off. Operate in Automatic Mode (with COLD Timer Activated) 1. Turn power switch ON and wait for LED display to light up. 2. Press the left hand “Auger ON/OFF” button ON. 3. To operate in COLD mode press the “AUTO TIMER” button until it is illuminated. 4. When setting automatic times, please keep in mind it will take time for the frozen product to become liquid or vice versa. Operate

Purpose of the Voltage Protector Module is to shut the Dispenser down should a too low or a too high power voltage condition occur. Retain these instructions as part of your equipment manual. LOOSE-SHIPPED PARTS Note: Only qualified personnel should install this Kit. Unpack and inspect kit. Make sure items are present and in good condition. Table 1. Loose-Shipped Parts Item No. Part No. Name Qty 1 XXXXXXXXX Voltage Protector Module 1 2 560003334 Electrical Wire (brown) 1 3 560003335 E

Retain these instructions as part of your equipment manual. INSTALLATION PROCEDURE FOR FLAT FLOOR DRAINS 1. Mount the wire form support in the center of the floor drain grid and clamp it s four legs of the support onto the drain grid securely. If necessary, reform the legs to fit and attach firmly to the drain grid. The clamps are omitted for clarity on the first two illustrations. 2. Place the plastic splashguard collar over the wire form support. 3. The adjustable clamps will accomodate 1/

The purpose of the Keyed Lock-Out Switch is to shut off electrical power to the dispensing valves to prevent dispensing of product. Retain these instructions as part of your equipment manual. LOOSE-SHIPPED PARTS Note: Only qualified personnel should install this Kit. Unpack and inspect kit. Make sure items are present and in good condition. Table 1. Loose-Shipped Parts Item No. Part No. Name Qty 1 560003869 Wiring Harness 1 2 560003870 Template, Hole Drilling 1 3 318948000 Lock Key 1

Conexion a fuente de alimentacion El cable de alimentacion del gabinete de vino esta equipado con un enchufe que encaja en cualquier enchufe estandar con conexion a tierra, para evitar cualquier riesgo de choque. Tenga la salida del poder verificada por un electricista calificado para para asegurarse de que es realmente a electricas a tierra. Si este no es el caso, debe tener lo sustituye con un conector que esta debidamente fundamentada Si el cordon esta danado, debe ser reemplazado por un Elec