Be sure and check the contents of the box against the package check list to be sure that all parts are included with the carrier that are required for proper installation. If any parts are missing or if any damage is noted, immediately contact the distributor from which you purchased your lift. DO NOT attempt to install or use the lift with any missing or damaged parts. OR CLASS 3 CLASS 2 OR CLASS 1 CARRIER ASSEMBLY STABILIZER OPTIONAL OPTIONAL HOLD DOWN ARM Each Tilt and Tote is packaged with a

• Take care not to hold one of the buttons on the Hand Controller until the Lifting Strap switches direction. The UP button should always pull the strap up and vice versa. If your buttons cause opposite movement, contact your distributor. Loading your Scooter or Power Chair —Enclosed Vehicle Applications Note: Due to the wide variety of scooters, power chairs and vehicles, your dealer may offer a different method for Loading and Unloading your scooter. Please follow the guidelines they have offe

This manual is written to be used both as an installation guide as well as an operation guide for the end user for both the AL010 Micro Scooter Lift and AL030 Manual Wheelchair Lift. Refer to the index below for the sections that apply to your lift and options. Please read the manual thoroughly BEFORE attempting any installation, adjustment or use of the lift. Both installers and operators should familiarize themselves with this entire manual. The manual will be divided into the following sectio

Caution: Before driving off with your scooter on the lift, make sure that the scooter is firmly held down on the platform. Caution: When driving with your scooter on the lift, slow down for pot holes, speed bumps, railroad tracks, etc. Your lift could be damaged by abuse if subjected to excessive loads imposed by rough driving. Caution: Do not enter steep driveways straight on. Enter and leave at an angle to the street so that you lift platform does not drag on the ground. Caution: Do not attemp

when drilling holes for mounting hardware! Figure 5.1 Figure 5.2 Power Base Installation of Base • Place the assembled lift as it is configured in the shipping carton into the desired location. • Bolt the Lifting Arm to the Post using the supplied 5/16” x 3-3/4” hex bolt and lock nut. • Raise the Lifting Arm to achieve an 1/8” clearance to the lowest point of the vehicle’s roof that the lifting arm will encounter during its travel (usually the door opening or rear A/C vents). • Unscrew the Adjus

• To assemble your lift, begin by inserting the Post into the Arm assembly. Next, slide the Power Frame onto the top of the Post. Line up the Red stripe on the Power Frame, Rotation Limit Collars, and Arm assembly. • Plug in the Hand Control. • By pressing the DOWN button on the Hand Control harness, run the Strap Hook down until it is slightly lower than the docking device on the scooter. • Attach the Strap Hook to the docking device on the scooter or chair and remove any play in the strap by p

This manual is written to be used both as an installation guide as well as an operation guide for the end user. Please read the manual thoroughly BEFORE attempting any installation, adjustment or use of the lift. Both installers and operators should familiarize themselves with this entire manual. The manual will be divided into the following sections for easy reference; Section 1 - Unpacking the Lift Section 2 - Vehicle Preparation Section 3 - Wiring the Vehicle Section 4 - AL200 Installation &

If any parts are missing or if any damage is noted, immediately contact your Harmar Dealer. DO NOT attempt to install or use the lift with any missing or damaged parts. Models AL010and AL050 are packaged with a standard Class 2 hitch adapter. Model AL030 is packaged with a standard Class 1 flat bar style hitch adapter and stabilizer. If a different model hitch adapter or a Swing Away option is required, separate parts must be ordered. Vehicle Wiring Instructions BLACK WIRE BLACK WIRE OR Side mou