tea and coffee carry a 90 day warranty; and, decanters are excluded. THIS WARRANTY IS THE COMPLETE AND ONLY WARRANTY, EXPRESSED OR IMPLIED IN LAW OR IN FACT, INCLUDING, BUT NOT LIMITED TO, WARRANTIES OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE, AND/OR INDIRECT OR CONSEQUENTIAL DAMAGES IN CONNECTION WITH BLOOMFIELD PRODUCTS. This warranty is void if it is determined upon inspection by an Authorized Service Agency that the equipment has been modified, misused, misapplied, improperly i

7. Rinse all surfaces with a clean soft cloth dampened with clean water. 8. Wash, rinse, and sanitize oven racks and replace in oven. 18 CLEANING INSTRUCTIONS (continued) CLEANING INSTRUCTIONS (continued) GRIDDLE CLEANING INSTRUCTIONS PRECAUTIONS Griddle surfaces are HOT. Wear appropriate heat protective gloves, apron and goggles FREQUENCY As Noted TOOLS Scraper, Pumice Stone or Griddle Brick Clean Cooking Oil Mild Detergent, Soft Cloth or Sponge Plastic Scouring Pad 1. To keep the griddle clean

LEVELING THE UNIT 1. Verify that an adjustable leg is installed at each corner of the brewer. 2. Set Brewer in its operating location. 3. Level the Brewer. A spirit level should be placed on the top of the unit, at the edge, as a guide when making level adjustments. 4. Level the unit from left to right and front to back by turning the adjustable feet. Be sure all four feet touch the counter to prevent tipping. PLUMBER’S INSTALLATION INSTRUCTIONS 1. Brewer should be connected to a POTABLE WATER,

2. All problems due to electrical connections not made in accordance with electrical code requirements and wiring diagrams supplied with the equipment. 3. Replacement of items subject to normal wear. Normal maintenance functions are not covered under warranty. 4. Proper attention, full care and maintenance will prolong the life of the machine. SHIPPING DAMAGE CLAIMS PROCEDURE SHIPPING DAMAGE CLAIMS PROCEDURE Note: For your protection, please note that the equipment in this shipment was carefully

12 685 77110 Owners Manual Horizon™ Brewers 685 77110 Owners Manual Horizon™ Brewers SERVICING INSTRUCTIONS (continued) TEMPERATURE ADJUSTMENT Disconnect brewer from electric power. Remove top panel. Remove button plug from front panel. Pull vent tube out of tank lid and insert a thermometer of known accuracy in hole. Reconnect brewer to electrical power. Place empty container under brew chamber. Energize brewer and allow unit to heat. When READY light glows, read the temperature displayed on th

Fig. 11 Adjust Solenoid Time IMPORTANT: Before setting assembly into tank, make sure tank lid gasket is properly seated on flange of lid. IMPORTANT: When mounting thermostat, be sure a new seal washer is placed below the fitting on the capillary line. Push sensing bulb thru tank lid until fitting seats. Tighten capillary lock nut only enough to ensure no water leakage. Excessive tightening is not necessary. 13 SERVICING INSTRUCTIONS (continued) REPLACE HEATING ELEMENT Remove tank cover assembly

IMPORTANT: Contact a licensed electrician to install and connect electrical power the broiler. Electrical installation must be performed by a licensed electrician in compliance with all local ordinances and code requirements. IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty. This broiler is not fused. Protect the circuit with properly sized fuses or circuit breaker. An electrical disconnect must be installed readily accessible to the operator of

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS FRYER. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment. ELECTRIC PRESSURE FRYER MODEL WFPE-30F Part No. 301626 Rev (-) M362 111500 cps INSTALLATION, OPERATION AND MAINTENANCE MANUAL FOR WELLS MANUFACTURING COMPANY 2 ERIK CIRCLE, P. O. Box 280 Verdi, NV 89439 Customer Service (775) 345-0444 Ext.502 fax: (775) 345-0569 362 LIMITED WARRANTY STATEMEN

763 p/ n 77719 OpManual Decanter Warmers Do not discard this appliance as usual trash at the end of its useful life. Recycle properly. AGENCY LISTING INFORMATION This warmer is listed under UL file E9253. C US C US This brewer meets Standard 4 only when installed, LISTED E9253 operated and maintained in accordance with the enclosed instructions. STD 4 3 INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS READ THIS CAREFULLY BEFORE STARTING THE INSTALLATION CAUTION: EQUIPMENT DAMAGE DO NOT plug i

View Water Temperature in Tank: To view the water temperature on the screen, the E-Max™ brewer must be ON, and not brewing or in the filling mode. Press and hold the 4th key, and depress the 6th key. The actual water temperature will be displayed for 3 seconds. 2. Daily Brew Count: The E-Max™ maintains a count of the number of completed brews for a 7-day period. To access the count, turn the brewer OFF. In the OFF mode, press and hold the CANCEL key for 3 seconds. The current day and brew count