48245 BLACK L1 HOT LIMIT T JUMPER WHITE L2 NEUTRAL BLOCKED T VENT SAFETY GROUND SWITCH F (CANADA JUNCTION BOX ONLY) F CAD CELL OIL VALVE ORANGE BURNER MOTOR IGNITOR Figure 11 TYPICAL PRIMARY CONTROL BURNER JUNCTION BOX WIRING (48245). . 11 . Startup Installation Checklis. Check Here NOTE: refer to the instruction manual supplied with the burner for installation, start up and adjustment. MAKE SURE THAT THE HEATER IS FULL OF WATER. See .Filling the Water Heater. section. DO NOT ATTEMPT TO START BU

Air Supply CAUTIO. IF AN ALL-HOUSE VENTILATION FAN IS USED, A SEPARATE OUTSIDE AIR DUCT MUST BE USED AND DUCTED TO THE FURNACE ROOM AND/OR ROOM WHERE THE WATER HEATER IS LOCATED. In Canada: If the water heater is installed in a house built to the requirements of the .National Building Code of Canada, 1985., or a subsequent edition, the space shall be provided with a air inlets as outlined below, or have a mechanical air-supply system of sufficient equivalent capacity. If a mechanical air- supply

• Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. WHAT TO DO IF YOU SMELL GAS PART NO. 72090 REV. D (07-11) GSW Water Heating is a division of A. O. Smith Enterprises Ltd. This page intentionally left blank. May be used for notes or to record other installation information. – 2– TABLE OF CONTENTS I) INT

INSTRUCTION. For Brands. GSW. John Wood. SpaceSaver. GSW Moffa. TABLE OF CONTENTS I) Introduction . . . . . . . . . . . . . . . . . . . . . .2 II) Safety . . . . . . . . . . . . . . . . . . . . . . . . . .2 III) Installation . . . . . . . . . . . . . . . . . . . . . . .2 IV) Operation . . . . . . . . . . . . . . . . . . . . . . .3 V) Maintenance . . . . . . . . . . . . . . . . . . . . .4 Warranty . . . . . . . . . . . . . . . . . . . . . . . .6 PLEASE RETAIN THESE INSTRUCTIONS IN . SAFE LOCATION

NOTE: Rear and Combination flue units must be fitted with a T&P Relief Valve WATTS type 40XL-5 or equivalent. Failure to install and maintain a new, properly listed temperature and pressure relief valve will release the manufacturer from any claims which may result from excessive temperature or water pressure. Closed Water Systems During the heating cycle of the water heater the water expands creating a pressure build-up in the water system. The water supply meter may contain a check valve or ba

GSW Units/parts must be replaced with GSW or John Wood products to be eligible for Warranty. This Warranty is available to the original owner of a Unit installed within the boundaries of continental United States, of Canada, or their territories. Consumers must retain point-of-sale proof of purchase to validate warranty entitlement. This Warranty does not cover components not manufactured by GSW, such as oil burners, which carry the warranty given by the manufacturer thereof, copy of which warra

(USA). • .Standard for Chimneys, Fireplaces, Vents, and Solid Fuel-Burning Appliances (NFPA 211). (USA). NFPA 211 requires the chimney to be lined before connect ing the oil-fired water heater. Inspect existing chimney before installing the water heater. Failure to do any of the following can result in serious property damage, severe bodily injury or death: • Clean the chimney, including removal of blockage. • Repair or replace damaged pipe or liner. . Repair mortar and joints. To prevent downdr

For assistance or additional infor- mation, consult a qualified installer, serv- ice agency, or the gas utility. FOR YOUR SAFETY • Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. • Installation and service must be per- formed by a qualified installer, service agency or the gas utility. WARNING: If the information in these instructions is not followed exactly, a fire or explosion may result causing property damage, per- sonal inj

. . . . . . . . . . . . . . . . . . . . . . . . . . . .3 II) Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 III) Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 IV) Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 V) Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8 PLEASE RETAIN THESE INSTRUCTIONS IN A SAFE LOCATION FOR F

Filling & Draining Tank ... Installation Checklist ....... Temperature Adjustment. .1 .1 .2 .2 .2 III) IV) V) VI) Service And Maintenance ..............................2 to 3 VII) Trouble-Shooting....................................................3 VIII) Pressure Buildup (Thermal Expansion) ................4 IX) Warranty................................................................5 PLEASE RETAIN THESE INSTRUCTIONS IN A SAFE LOCATION FOR FUTURE REFERENCE A FOR YOUR SAFETY • D