Directed Electronics has been the industry leader in high-quality automotive security and audio equipment since 1990, and with the introduction of the Directed Studio line of high-quality loudspeakers for the automobile, Directed continues to set new standards of performance, reliability, and affordability in the mobile electronics industry. Featuring injection-molded fiberglass reinforced baskets with graphite injected cones and neodymium motors, the Directed Studio line of automotive speakers

(Refer to the trim ring information at the end of this section.) © 2003 Directed Electronics, Inc Tweeter Surface Mounting 1. Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. 2. Place the surface mount housing against the panel and mark the two holes at the rear of the housing. 3. Drill the smaller center hole using a 1/8" drill bit. This is the mounting screw hole. 4. Drill the larger off-center hole using a 3/8" drill bi

Note: This warranty does not cover labor costs for the removal and reinstallation of the unit. IN ORDER FOR THIS WARRANTY TO BE VALID, YOUR UNIT MUST BE SHIPPED WITH PROOF OF INSTALLATION BY AN AUTHORIZED DEI DEALER. ALL UNITS RECEIVED BY DEI FOR WARRANTY REPAIR WITHOUT PROOF OF DEI DEALER INSTALLATION WILL BE COVERED BY THE LIMITED 1 YEAR PARTS AND LABOR WARRANTY. Note: This warranty does not cover labor costs for the removal and reinstallation of the unit. BY PURCHASING THIS PRODUCT, THE CONSU

Zwischen der Tur und der Turschwelle befindet sich eine Stabilisator-Anschlagleiste. Diese Leiste verhindert, dass die Tur sich zu weit offnet. Viele Amateur-Einbauer ubersehen das und prufen nur den Freiraum bei voll geoffneter Tur (abbildung 1). EINBAU IM KOFFERRAUM Beim Einbau im Kofferraum ist auf die Funktionsfahigkeit der Kofferraumfedern oder Zugstabe zu achten. Diese Zugstabe bewegen sich beim Offnen und Schlie.en des Kofferraums. Seien Sie bei diesem Teil der Installation besonders vors

Instalacion del Tweeter MONTAJE EN SUPERFICIE Paso 1: Determine la ubicacion de montaje del tweeter y luego encamine los cables provenientes del crossover hasta la ubicacion del tweeter. Paso 2: Ponga la plantilla suministrada o la copa del tweeter contra el panel y marque los dos agujeros en la parte de atras del alojamiento. Paso 3: Haga los agujeros pequenos con una broca de 1/8 plg. Estos son los agujeros de los tornillos de montaje. ADVERTENCIA: Verifique que haya espacio para los mecanismo

Thermal protection is also indicated by the green LED shutting off. 5 © 1999 Directed Electronics, Inc SPEAKER WIRING DIAGRAMS Stereo operation Mono operation For bridged two channel operation as shown in this diagram, connect right channel RCA cables to the “Front” inputs of the amplifier, and left channel RCA cables to the “Rear” inputs of the amplifier. For summed subwoofer applications, connect RCA cables per the input jack marking. Simultaneous stereo/mono operation (two channel shown) © 19