Panasonic YCEU1212
Descargado: 2Tamaño del archivo: 970 kb
Fabricar: Panasonic
Categoría: Otros dispositivos personales
Categoría: Otros dispositivos personales
Comentarios
Descargar ahora
Если код правильный, оборудование включается или выключается. Если этого не произойдет, попробуйте ввести другой код. 0VD TV 2СН6СН ООО ООО © о о шт жм •на ei йй шин ши в Si! IIÍÉI Este mando a distancia puede controlar equipos audiovisuales Panasonic y Technics que dispongan de sensores de mando a distancia. Puede que sea necesario cambiar el código del mando a distancia. También puede controlar televisores, videograbadoras y reproductores DVD de otras marcas. Compruebe las marcas
See “REF Level Setting”. 3. On the AD converter, select output channels: 1-4 or 5-8: after entering the SHIFT operation mode if 88.2 or 96 kHz is used. The selected channel outputs will be recorded on the ADAT's tracks: output channels “1, 2, 3 and 4” or “5, 6, 7 and 8” will be recorded onto track 1/2, 3/4, 5/6 and 7/8 respectively. (1) To enter the SHIFT operation mode press the WORD LENGTH button for 2 second or more. (2) Press the FREQ button to select output channels. The FREQ LEDs indica
/7% □□□□ □□□ -, Dili_HHHH r loj W 1 Ico hf , i : ul Unit : mm Model No. WZ-DE45NH Input No. of Channels 2 ch Analog Type Electronic balance Rated Input +4 dB Maximum Input +24 dB or more Connector XLR-3-31 or equivalent, x2 Input Impedance 20 kfí In-Phase Reject Ratio 40 dB or more A/D Converter 24-bit A-Z type Digital Type AES/EBU format, for professional use Sampling Frequency 48 kHz±0.1% Connector XLR-3-31 or equivalent, 1 connector Output No. of Channels 2 c
WZ-AESAD RAMSA и Dual AES Outpul Card WZ-AESAD 0{ 1© AES/EBS DIGITAL OUTPUT - «1 Before attempting to oonnect or ooerato this product, please read these instructions carefully and save this manual for future use Introduction The WZ-AESAD is an option card to be installed in the AD Converter WZ-AD 96 and WZ-AD96M. This card supplies an 8-channel, 24 bit, 96 kHz signal to the connected MTRs. Warning! The installation shown below should be made by qualified service personnel or system
The microphone should not be placed less than 6.7ft (2m) from the antenna under any circumstance. 7. When using multiple wireless microphones, the transmitters should be at least 1,6ft (50cm) apart from each other. -1- MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS Front Panel WX-RP810 O ’»«tv Dt(e