12 FIN Sisallysluettelo ..............................................................22 DK Indholdsfortegnelse ....................................................... 32 UK Contents ............................................................................ 43 Contents Safety instructions ............................................................................ 43 Description of the cooker hood .......................................................... 44 Introduction ......................

AEG - putting words into action. Introduction The hood is supplied as an extractor unit and can also be used with a filtering function by fitting activated carbon filters (special accessory). The unit features two outlet holes, one of which A is located on the top of the unit while the other B is located on the rear. To connect up the hose, you should first fit the bayonet-mounting flange C on the outlet required (if using the top outlet, fix the flange in place using the screw supplied as s

1). Close off the unused hole using the bayonet fitting caps D. • Important! To use the back hole B, remove switch F from the top hole. — Fig 2. 4 • Move the lever L to position A — Fig. 3. • When connecting up the hood using a telescopic wall pipe, you should use an uninflammable outlet hose ABS 120 (120 mm 0) available as an accessory. Recirculation mode • The air is filtered and recirculated through the front grid. • Move the lever L to position F — Fig. 3. You will need an original K

AEG - putting words into action. View of the Hood 1) Extendable Vapour Guide 2) Filter Grille 3) Lighting 4) Motor Switch 5) Light Switch 1 5—arD*. ш. General Extraction mode The cooker hood can be used : either as an exhaust air appliance (extraction mode) or as a return air appliance (recirculation mode) via a carbon filter (optional extra). Preparation for installation In this mode the fumes are extracted to the outside via a venting hose connected to the coupling ring A, plac

¦ Down draught extractor ¦ Touch controls with LED display ¦ Touch controls ¦ Variable 4 speed control including ¦ Variable 4 speed control including 1 intensive setting 1 intensive setting ¦ Delayed switch off timer and auto safety ¦ 2 heights of operation, fully retracts to switch off worktop level when not in use ¦ Delayed switch off timer and auto safety switch off PERFORMANCE 480m3/h extraction rate 65dB(A) noise level Extraction and recirculation Removes grease and odours directly from the

3 Using the cooker hood ............................................... 4 Maintenance and cleaning .......................................... 5 What to do if .............................................................. 7 Service and Spare Parts ............................................. 8 Customer Care ........................................................... 8 Guarantee Conditions ................................................. 9 Technical data .........................................

Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation... The safety cut-out device has beentripped. Turn off the hob and then wait for the device to reset. If the hood has been installed belo

Fig. 2. • Optionally, the position of the chimney elements can be changed. When using the hood in the filter version the chimney must be fixed at the top, with the air outlet grill at the side. Fig. 1 Fig. 2 Description of the Appliance • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter. • You will need an original AEG charcoal filter for this function (Available from your local AEG Service Force Centre). Extractor version •