Si el punta de desconexion de la energia esta fuera del alconce de la vista, asegure el interruptor en posicion abierta y coloque una etiqueta de advertencia para evitar la aplicacion inadvertida de energia. 5. Libere toda la presion dentro del sistema antes de dar servicio a cualquier componente. 6. Drene todos los liquidos del sistema antes de darle mantenimiento. 7. El motor de la bomba esta equipado con un dispositivo automatico de reajuste de proteccion termica, y podria arrancar inesperada

The gas supply to the infra-red heater must be connected and tested in accordance with national, state, provincial and local codes along with the guidelines in this manual. Refer to the latest edition of the ANSI Z223.1 (NFPA 54) Standard. Important! Before connecting the gas supply to the infra-red heater(s): • Check for conditions such as drafts or other variables which might cause excessive movement of the unit and cause damage to the gas connection. Ensure that the unit is securely mounted a

Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain these instructions for future reference. Dayton® Patio Heaters Description Dayton high-intensity patio heaters become highly efficient generators of infrared radiation by heating a ceramic refractory material to incandescence. The principal operation is to pass a gas-air mixture through a perforated ceramic refractory, and ignite it o

If you see globules of water in the bottom, drain and flush the tank and filter with clean fuel, b. Refill with fresh, clean fuel. FORM 5S1792 MODELS 2E510A, 2E511 A, 3E218A & 3E219 01582. Trouble Shooting Chart (Continued) SYMPTOMS POSSIBLE CAUSE(S) CORRECTIVE ACTION Heater burns, but puffs 2. Dirty air filters causing reduced 2. Remove and clean the air filters. of smoke can be seen; air flow through nozzle, resulting Be sure air intake is not blocked. heater will not burn in low

FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE. Description Dayton portable oil-fired heaters are designed to provide temporary heat. They must be used with adequate ventilation, 120V, 60 Hz electrical power, and kerosene, or No. 1 fuel oil. THEORY OF OPERATION 1. There are four basic systems within the heater: the fuel system, air system, ignition system, and flame-out control system. 2. An air pump on o

Install the wheels (6) on the axle. IMPORTANT: The extended hub of the wheel should be positioned to- " ward the wheels support frame. Position the cap nuts (9) on the axle ends and gently tap with a hammer to secure. 2. Position the heater on the wheel support frame assembly with the combustion chamber end over the wheels. 3. Use four screws (7) and nuts (8) to attach the front handle to the top of the tank flange. The screws will go through the front handle, the tank flange and the wheel su

NO. DESCRIPTION PART NO. QTY. REF. NO. DESCRIPTION PART NO. QTY. 1 2 3 4 Upper shell Screw, #10-16 x 1/2" Combustion chamber assembly Photocell bracket 098511-64 M15823-27 098512-07 M16660 1 8 1 1 27 28 29 30 Bushing Bushing Screw, #10-16 x 1/2" Clip nut M30865-02 M50104-02 M11084-27 M11271 -8 1 1 5 6 7 8 Screw, #6-32 x 3/8" Photocell assembly Burner assembly Screw, #10-16 x 1/2" M10908-2 M16656-4 ■ t M11084-27 1 1 31 32 33 34 Screw, #8-18 x 1/4" Fuel tank Fuel cap (includes gasket) Flame out

PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. General Safety Information ▲warnings WARNING: Improper use of this heater can cause serious injury or death from burns, fire, explosion, electrical shock, and carbon monoxide poisoning. DANGER: Carbon monoxide poisoning may lead to death! Carbon Monoxide Poisoning: Early signs of carbon mono